Muhammad Salman Khan

Muhammad Salman Khan

Auto-generated profile, based on publicly available information

Muhammad Salman Khan

Department of Physics, Abdul Wali Khan University, Mardan, 23200, Pakistan

Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2023 in ACS Omega
Verified
Journal Article
Open access
SKShaukat Khattak
Shaukat Khattak
MAMohammed Abohashrh
Mohammed Abohashrh
Imtiaz AhmadImtiaz Ahmad
Imtiaz Ahmad
MHMudasser Husain
Mudasser Husain
IUIrfan Ullah
Irfan Ullah
VTVineet Tirth
Vineet Tirth
Coded within Wien2K, we carry out DFT-based calculations for investigations of the structural, elastic, optoelectronic, and thermoelectric properties of BaXF3 (X = Co, Ir) fluoro-perovskites. The Birch-Murnaghan fit to the energy-vs-volume data and formation energy shows that these fluoro-perovskites are structurally stable. The phonon calculation confirms the thermodynamic stability, while the relation between elastic constants such as C 11 - C 12 > 0, C 11 > 0, C 11 + 2C 12 > 0, and B > 0 validates the mechanical stability of the compounds. BaIrF3 exhibits a strong ability to endure compressive and shear stresses. BaCoF3 shows a weaker capacity of withstanding changes in volume, attributed to a lower bulk modulus. Demonstrating a higher G-modulus of rigidity than the BaIrF3, BaCoF3 demonstrates stronger resistance to change the shape and both compounds are found to be anisotropic and brittle. The determined band structure profiles reveal that both BaCoF3 and BaIrF3 demonstrate a metallic nature. In addition, the metallic nature of BaCoF3 and BaIrF3 is reinforced by the density-of-states (DOS) study, where Co and F atoms contribute significantly to the total DOS in the valence band in the case of BaCoF3, while that of BaIrF3 is predominated by the Ba and F atoms. The computed values of ε1(0) for BaCoF3 and BaIrF3 are approximately 30 and 19, respectively, which are in line with Penn's model. The researched materials are confirmed to be strong contenders for optoelectronics by the lack of absorption in the visible range. For their potential use in thermoelectric device applications, thermoelectric parameters such as temperature-dependent Seebeck coefficient, specific heat capacity, thermal conductivity, power factor, and figure of merit are also investigated, which show that these materials are thermally stable and promising for applications in thermoelectric devices.

15 August 2023 in Materials Advances
Verified
Journal Article
Open access
PDF file
BGBanat Gul
Banat Gul
MKMuhammad Salman Khan
Muhammad Salman Khan
BABashir Ahmad
Bashir Ahmad
MRMostafizur Rahaman
Mostafizur Rahaman
PLParide O. Lolika
Paride O. Lolika
HAHijaz Ahmad
Hijaz Ahmad
The band structures confirmed an indirect band gap semiconductor nature. All the static dielectric constant values demonstrate a decreasing tendency with the energy gap value.

13 April 2023 in ACS Omega
Verified
Journal Article
Open access
HAHazem Abu-Farsakh
Hazem Abu-Farsakh
BGBanat Gul
Banat Gul
MKMuhammad Salman Khan
Muhammad Salman Khan
CdTe is a potential material for making efficient and stable solar cells. The present study aimed to systematically investigate the electronic, optical, and thermoelectric properties of different structural phases of CdTe using density functional theory. The electronic properties were calculated using the modified Becke–Johnson potential with the local density approximation (LDA) correlation. The band structure profiles showed a direct band at the Γ-point for α-cubic, β-hexagonal, γ-orthorhombic, and an indirect band type for the δ-trigonal phase from the A-point at valence band maximum to the Γ-point at conduction band minimum. Hybridization between Te-p and Cd-s bands in the main valence region was observed in the partial density of states plots for all the studied phases. The real component static values of the dielectric function showed a slight decrease with increasing photonic energy after an initial small increase. The intensity of the imaginary component increased above the threshold energy for each phase, with the δ-phase showing a higher reflectivity spectrum than the other phases due to its intense peaks, making it ideal for protecting against high energy radiations. The results indicated that our computed band gaps and refractive index n(ω) were inversely related. The thermoelectric parameters calculated for these phases suggest that they have potential to be used in thermoelectric devices.

13 November 2022 in Journal of Solid State Chemistry
Verified
Journal Article
Closed access
BGBanat Gul
Banat Gul
MKMuhammad Salman Khan
Muhammad Salman Khan
HAHijaz Ahmad
Hijaz Ahmad
Phatiphat THOUNTHONGPhatiphat THOUNTHONG
Phatiphat THOUNTHONG

29 April 2023 in Journal of Materials Science
Verified
Journal Article
Closed access
PDF file
MBMerieme Benaadad
Merieme Benaadad
BGBanat Gul
Banat Gul
MKMuhammad Salman Khan
Muhammad Salman Khan
ANAbdelhakim Nafidi
Abdelhakim Nafidi

29 July 2022 in Journal of Materials Chemistry C
Verified
Journal Article
Closed access
PDF file
MKMuhammad Salman Khan
Muhammad Salman Khan
BGBanat Gul
Banat Gul
HAHazem Abu-Farsakh
Hazem Abu-Farsakh
GKGulzar Khan
Gulzar Khan
In the present work, an in-depth study was conducted on the structural, optoelectronic, and thermoelectric nature of novel ternary-type NaLiX (X = S, Se, Te) chalcogenides. The WC-GGA exchange correlation and the most accurate TB-mBJ method within the framework of density functional theory were used to calculate the electronic properties. Bandgap calculations with TB-mBJ potential show a direct band transition nature with gap values of about 3.59 eV for NaLiS, 2.87 eV for NaLiSe, and 2.73 eV for NaLiTe. Decreasing bandgap values in the order of NaLiS → NaLiSe → NaLiTe are attributed to the reduction of electronegativity while going from S to Te anions in these materials. The wide energy bandgaps in these materials reveal that the bonds involved have a strong covalent nature. Our calculated density of states plots shows a similar overall trend, indicating that the top of the valence bands in all these materials originate primarily from the p-states of the chalcogen anions. The computed electron effective masses decrease in the order of NaLiS → NaLiSe → NaLiTe, which implies that the flatness of the energy band at the CBM decreases at the Γ-point. Additionally, the linear optical constants, such as the complex dielectric function, refractive index, electron energy loss function, absorption coefficient, and reflectivity spectra of these novel chalcogenides were computed and examined in detail for their possible applications in optoelectronic devices. The thermoelectric transport properties were also computed, and the attained results are discussed in detail, which suggest these materials are efficient for thermoelectric device applications. The current work essentially supports the advancement of discrete and integrated semiconductor device applications.