The layup process of large composite structures made from dry reinforcement fabrics is considered. One such structure is a wind turbine blade, for which the current draping process is mostly manual. Automating the draping process will, therefore, lower the costs. Based on a literature review, a new concept is synthesized and analyzed using an advanced finite element model with rigid multi-body kinematics and a dedicated material model for the fabric. The material model is calibrated using experimental coupon tests, i.e. the bias-extension test (shear) and Peirce's cantilever test (out-of-plane bending). The concept is analyzed numerically by means of a simple parameter study and draping test cases on a flat mold as well as a general double-curved mold. The simulation results show that the concept is feasible for the draping operation and is thus qualified for the subsequent physical prototyping.
PVC gels are gaining more attention in the applications of soft actuators. While their characteristics have been extensively studied experimentally, precise models that predict the deformation due to imposed mechanical and electrical forces are not yet available. In this work, a viscoelastic model based on a combination of a Maxwell and a Kelvin–Voigt model is developed to describe the responsive deformation of the actuator. The model parameters are tuned using data obtained from a unique experimental setup. The PVC gel used in the actuator is made from PVC and dibutyl adipate (DBA) together with a tetrahydrofuran (THF) solvent. A full factorial test campaign with four and three levels for the mechanical and electrical forces, respectively, are considered. The results showed that some of the viscoelastic response could be captured by the model to some extent but, furthermore, the stiffness behavior of the PVC gel seemed to be load-type-dependent, meaning that the PVC-gel material changed stiffness due to the magnitude of the electrical force applied and this change was not equal to a similar change in mechanical force.