12 January 2014 in Mathematical Problems in Engineering
In practical structural health monitoring (SHM) process based on wireless sensor network (WSN), data loss often occurs during the data transmission between sensor nodes and the base station, which will affect the structural data analysis and subsequent decision making. In this paper, a method of recovering lost data in WSN based on compressive sensing (CS) is proposed. Compared with the existing methods, it is a simple and stable data recovery method and can obtain lower recovery data error for one‐dimensional SHM’s data loss. First, response signal x is measured onto the measurement data vector y through inner products with random vectors. Note that y is the linear projection of x and y is permitted to be lost in part during the transmission. Next, when the base station receives the incomplete data, the response signal x can be reconstructed from the data vector y using the CS method. Finally, the test of active structural damage identification on LF‐21M aviation antirust aluminum plate is proposed. The response signal gathered from the aluminum plate is used to verify the data recovery ability of the proposed method.
19 December 2017 in Journal of Sensors
In order to ensure the safety of composite components, structural health monitoring is needed to detect structural performance in real-time at the early stage of damage occurred. This is difficult to detect complex components with single sensor detection technology, so that ultrasonic phased array technology using multisensor detection will be selected. Ultrasonic phased array technology can scan the structure in all directions and angles without moving or less moving the probe and becomes the first choice of structural health monitoring. However, a large amount of data will be generated when using ultrasonic phased array with Nyquist sampling theorem for structural health monitoring and is difficult to storage, transmission, and processing. Besides, traditional Nyquist sampling cannot satisfy the sampling of large amounts of data without distortion, so a more efficient acquisition technique must be chosen. Compressive sensing theory can ensure that if the signal is sparse, it can be sampled in low sampling rate which is much less than two times of the sampling rate as defined by Nyquist sampling theorem for a large number of data and reconstructed in high probability. Then, the experiment result indicated that the orthogonal matching pursuit algorithm can reconstruct the signal completely and accurately.
1 November 2013 in International Journal of Distributed Sensor Networks
Near-field ultrasonic phased array theory is researched and utilized in the carbon-fiber wing box to identify the damage in the structure. Near-field ultrasonic phased array based structural health monitoring is researched to overcome the limitation of the far-field ultrasonic phased array in monitoring scope. The time delay of the theory and the process of the damage identification method are researched in detail. The recognition result is shown in a mapped image. The proposed method is applied in carbon fiber-reinforced polymer (CFRP) wing box to monitor the load in the structure. The experimental results show that the near-field ultrasonic phased array based structural health monitoring method is effective to identify the load position in the structure.
1 January 2019 in International Journal of High Performance Computing and Networking