1 November 2016 in Catalysis Today
22 June 2018 in Green Chemistry
AHAna M. Hernández-Giménez
+6
The properties of the zeolite ZSM-5 have been optimised for the production and deoxygenation of the bio-oil* (bio-oil on water-free basis) fraction by lignocellulose catalytic pyrolysis. Two ZSM-5 supports possessing high mesopore/external surface area, and therefore enhanced accessibility, have been employed to promote the conversion of the bulky compounds formed in the primary cracking of lignocellulose. These supports are a nanocrystalline material (n-ZSM-5) and a hierarchical sample (h-ZSM-5) of different Si/Al ratios and acid site concentrations. Acidic features of both zeolites have been modified and adjusted by incorporation of ZrO2, which has a significant effect on the concentration and distribution of both Brønsted and Lewis acid sites. These materials have been tested in the catalytic pyrolysis of acid-washed wheat straw (WS-ac) using a two-step (thermal/catalytic) reaction system at different catalyst/biomass ratios. The results obtained have been assessed in terms of oxygen content, energy yield and composition of the produced bio-oil*, taking also into account the selectivity towards the different deoxygenation pathways. The ZrO2/n-ZSM-5 sample showed remarkable performance in the biomass catalytic pyrolysis, as a result of the appropriate combination of accessibility and acidic properties. In particular, modification of the zeolitic support acidity by incorporation of highly dispersed ZrO2 effectively decreased the extent of secondary reactions, such as severe cracking and coke formation, as well as promoted the conversion of the oligomers formed initially by lignocellulose pyrolysis, thus sharply decreasing the proportion of the components not detected by GC-MS in the upgraded bio-oil*.
29 March 2016 in Catalysis Science & Technology
The present work focuses on the pathways through which catalytic pyrolysis of biomass into bio-oil proceeds and the effect of the operation conditions on parameters like bio-oil oxygen composition and mass yield, and also additional indicators, such as the distribution of both the oxygen and the chemical energy contained in the initial biomass among the different products. Acid washed wheat straw was used as biomass feedstock. The pyrolysis tests were performed in a lab-scale downdraft fixed-bed reactor working at atmospheric pressure, employing a nanocrystalline H-ZSM-5 zeolite as catalyst. A systematic study was carried out by decoupling both the thermal and catalytic reactions in order to evaluate the influence of three key variables: temperature of the thermal zone; temperature of the subsequent catalytic step and catalyst/biomass ratio. Increasing the pyrolysis temperature in the thermal zone resulted in more bio-oil* (bio-oil in water-free basis) production to the detriment of char and water fractions. In contrast, a significant reduction in bio-oil* fraction, due to decarbonylation and decarboxylation, occurred when increasing the catalytic bed temperature from 400 up to 500 °C. A similar effect was observed by varying the catalyst/biomass ratio since it increased the production of CO, CO2, light olefins and coke at the expense of a decline in the bio-oil* yield. Nevertheless, this bio-oil contains oxygen amounting to as low as 10 wt%, while retaining about 38% of the energy yield. Char, coke and gaseous hydrocarbons contain a great part of the biomass chemical energy, hence their formation should be suppressed or minimized to further improve the bio-oil* energy yield. At high catalyst/biomass ratios, the bio-oil becomes rich in aromatic compounds, both oxygenated and hydrocarbons, while the amount of sugars, furans, carboxylic acids, and other oxygenated products is strongly reduced.
24 May 2017 in Biomass Conversion and Biorefinery
COCristina Ochoa-Hernández
+2
1 December 2017 in Fuel Processing Technology