Jin-Tae Kim

Jin-Tae Kim

Auto-generated profile, based on publicly available information

Jin-Tae Kim

Korea Research Institute of Standards and Science (KRISS), Taedok Science Town, Taejon 305-600, South Korea

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 June 2008 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
JJJung Jin Ju
Jung Jin Ju
SPSuntak Park
Suntak Park
MKMin-Su Kim
Min-Su Kim
JKJin Tae Kim
Jin Tae Kim
SPSeung Koo Park
Seung Koo Park
MLMyung Hyun Lee
Myung Hyun Lee
We present characteristics of very thin Au strip waveguides based on long-range surface plasmon polaritons (LR-SPPs) along thin Au strips embedded in polymers. We also report a 10 Gbps optical signal transmission via LR-SPPs with the pig-tailed Au strip waveguide at a telecommunication wavelength of 1.55 mum. We limited the thickness, width, and length up to ~20 nm, ~ 10 mum, and ~5 cm, respectively, for practical applications. At 1.55 mum, loss properties of the Au strip waveguides were theoretically and experimentally evaluated with thickness, width and cladding material. The lowest propagation loss of ~1.4 dB/cm was experimentally obtained with the 14-nm-thick and 2-mum-wide Au strip. With a single-mode fiber, the lowest coupling loss of less than 0.1 dB/facet was achieved with the 14-nm-thick and 7.5-mum-wide Au strip. The lowest insertion loss was obtained 7.7 dB with the 14-nm-thick, 5-mum-wide, and 1.5-cm-long Au strip. The propagation loss was improved approximately 30% for the 17-nm-thick Au strip with lowering the refractive index of the cladding polymer by 0.01. In the 10 Gbps optical signal transmission experiment, the LR-SPP waveguide exhibits an excellent eye opening and a 2.2 dB power penalty at 10-12 bit error rate. These all results indicate that the LR-SPP waveguide is a potential transmission line for optical interconnects to overcome inherent problems in electric interconnects.

13 May 2002 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
KKK. S. Kim
K. S. Kim
HSH. J. Shim
H. J. Shim
IHI. J. Hwang
I. J. Hwang
BCB. K. Cho
B. K. Cho
JSJ. H. Seok
J. H. Seok
JKJin-Tae Kim
Jin-Tae Kim
The measurements of voltage fluctuations at room temperature are performed for magnetic tunnel junction, patterned by photolithography to have 20×10 μm2 in junction area. The observed noise power follows 1/f behavior for the whole applied magnetic field (H) range (−30 Oe⩽H⩽30 Oe) and shows strong field dependence. The sharp increase in noise power spectral density is observed near a transition region from antiparallel to parallel magnetic state in two electrodes during field ramping down. In addition, the reduction of noise power density is accompanied by the reduction of magnetoresistance ratio after thermal annealing at 300 °C for 700 s in the same junction. It is conjectured that the observed reduction of the noise level in our junction is due mainly to magnetic origin, such as thermally activated domain wall motion, rather than electrical origin.

15 May 2003 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
HSHeejae Shim
Heejae Shim
BCB. K. Cho
B. K. Cho
JKJin-Tae Kim
Jin-Tae Kim
TKT. W. Kim
T. W. Kim
WPW. J. Park
W. J. Park
We investigated the effects of nitrogen plasma treatment on top surface of Fe pinned layer for short times (tex=0, 10, 30, and 60 s) in magnetic tunnel junctions and annealing of the junctions. The nitrogen-treated junctions show much reduced magnetoresistance (MR) ratio and significantly lower resistance-area (RA) products compared with the untreated junction, i.e., MR≈3%, RA≈30 kΩ μm2 for tex=10 s and MR≈10%, RA≈60 kΩ μm2 for tex=0 s. The untreated junction showed enhanced MR ratio up to about 17% and higher RA (≈70 kΩ μm2) upon thermal annealing at Ta=230 °C, as expected. For the nitrogen-treated junctions, while the MR ratio also increases up to about 16% upon annealing at Ta=230 °C, which is almost the same value as the one of the optimal reference junction, the RA values of the annealed junctions still keep as low as their initial values. We believe that the redistribution of nitrogen during the annealing process is responsible for the change of properties of nitrogen-treated junction. The bias dependence of MR and the estimation of effective barrier height and thickness are studied and found to be consistent with the observed changes in nitrogen-treated junctions.

1 June 1999 in IEEE Transactions on Applied Superconductivity
Verified
Journal Article
Closed access
YHYunseok Hwang
Yunseok Hwang
BNByung-Chang Nam
Byung-Chang Nam
MLMoon Chul Lee
Moon Chul Lee
DKDong Wook Kim
Dong Wook Kim
SLSoon-Gul Lee
Soon-Gul Lee
ISI-Hun Song
I-Hun Song

1 March 2003 in Journal of Applied Physics
Verified
Journal Article
Closed access
PDF file
HSHeejae Shim
Heejae Shim
BCB. K. Cho
B. K. Cho
JKJin-Tae Kim
Jin-Tae Kim
We report an anomalous magnetotransport in a magnetic tunnel junction (MTJ) containing an Au dusting layer with Au thickness 0.6 nm at the Co/Al2O3 interface, where the Co layer is pinned by the underlying FeMn layer. Despite its structure being exchange biased, the junction with the 0.6 nm Au layer exhibits symmetric magnetoresistance (MR) for both the applied magnetic field (H) directions, which is a typical MR feature without a pinning effect, and a low resistance state near H≈0 Oe. It is also found that the same MR features, i.e., symmetric MR and a low resistance state near H≈0 Oe, can be achieved in the MTJ without an Au insertion layer when the pinned Co moments are at an angle to the applied H direction. Based on measurements of the angular dependence of MR, we surmise that the anomalous MR is due to the effect of spin disorder in the Co layer, induced by the deposited Au layer. It is not likely that the anomalous effect is due to the quantum well state in the Au layer.

1 January 1999 in IEEE Transactions on Magnetics
Verified
Journal Article
Closed access
KLKyu-Won Lee
Kyu-Won Lee
JKJin-Tae Kim
Jin-Tae Kim
DHDong-Han Ha
Dong-Han Ha
YPYong-Ki Park
Yong-Ki Park
JPJong-Chul Park
Jong-Chul Park
HKHo-Gi Kim
Ho-Gi Kim