In biomedical sciences, there is demand for electronic skins with highly sensitive tactile sensors, having applications in patient monitoring, human–machine interfaces, and on‐body sensors. In clinical applications, it would be especially beneficial if the sensors would be disposable. Here, an all plant‐material‐based biodegradable capacitive tactile pressure sensor for disposable electronic skins is reported. Silver‐nanowire‐coated leaf skeletons are used as breathable and flexible electrodes while freeze‐dried rose petals are used as the dielectric layer. The leaf skeleton electrodes have a rough fractal‐like architecture, which provides good adhesion to the silver nanowires and maintains interconnections between the silver nanowires when the electrodes are bent. The electrodes display low constant resistance up to curvature of 800 m−1. The rose petal dielectric layer has a multiscale 3D cell wall microstructure, which compresses elastically when subjected to pressure. The fabricated sensor can respond to pressures ranging from 0.007 to at least 60 kPa, with a maximum sensitivity of ≈0.08 kPa−1. The signal is stable for at least 5000 pressure cycles, after an initial break‐in period. Owing to the all biomaterial constituents, the sensor is biodegradable under aqueous conditions. The sensor is successfully applied as an e‐skin in touch sensing and gesture monitoring.
Tactile electronic skin (e-skin) has multitude of potential applications, such as a prosthetic artificial skin, wearable sensors and health monitoring. However, current fabrication methods tend to involve complex processing or materials that are not widely available. In this paper, we show that high quality capacitive tactile sensors for an e-skin can be fabricated by sandwiching a microstructured dielectric elastomer layer between two conductive fabric electrodes. The fabric can be easily cut to quickly prototype different sensor configuration and can be bent into three dimensional shapes. The fabricated sensors display excellent linearity and very little long-term drift. We demonstrate the integration of these sensors in an anthropomorphic robotic hand, which is entirely fabricated using rapid prototyping techniques.