This paper presents the results of the air quality measurements in the agglomeration of Bor in the period June-December 2022, in which the Copper Smelter in Bor was not working due to the works on reconstruction and increasing the capacity for copper concentrate processing. Based on an analysis of the existing measuring points and concentrations of pollutants, measured in the local and national air quality monitoring network in the territory of the Bor agglomeration, as well as the possible impact of the new mining and metallurgical facilities in the company Serbia ZiJin Copper Bor, the additional locations, where the measurements were performed, were selected. The air quality measurement results show that there was no exceedance of the hourly and daily limit values for gaseous pollutants, nor were there an exceedance of the limit value for the mean daily concentration of lead in the suspended particles of the PM10 fraction, as well as the target values for the concentrations of cadmium and nickel in PM10. The arsenic concentration in PM10 at the measuring point of PU Bor was above the target annual value for 3 days. The maximum measured mean daily value of arsenic concentration in PM10 at this measuring point was 11.3 ng/m3 . Based on a complete insight into the results of air quality measurements in the Bor agglomeration in 2022, it can be concluded that the dominant share of concentration of SO2 , CO, as well as the concentration of arsenic, cadmium, and lead in PM10, originates from the gaseous pollutant emissions from the Copper Smelter Bor in the period when it operates. It was established that at the measuring point MMI Bor, the nitrogen oxide emissions from traffic mostly affect the level of nitrogen oxides in the air. Also, the measurement results indicate that the operation of the Smelter in 2022 did not significantly contribute to the concentration increase of suspended PM10 particles in the agglomeration of Bor, and that during the period of operation of the Copper Smelter in 2022, no copper concentrates with increased nickel content were processed.
The air quality in the city of Bor in 2023 is analysed in this paper. In the period from May 1, 2022 until April 1, 2023 the copper smelter in Bor was not working due to reconstruction and capacity increase. The analyses show that in 2023, no exceeding of the daily limit value for SO2 , PM10, and soot concentrations was detected at any measuring point. During the reconstruction of the copper smelter, correlation coefficients (Pearson) at measurement point "Jugopetrol" between PM10 and the chemical elements Cd and As were moderate (0.6>r>0.4), while in the period before and after the reconstruction of the smelter, they were strong (0.8>r>0.6), and very strong (r>0.8). The results presented in the paper indicate that despite the reconstruction of the copper smelter, the problem of emission of high concentrations of carcinogenic elements in PM10 from the copper smelter is still present. It is necessary to urgently implement additional measures to reduce these emissions to the values provided by law.
The subjective experience of the environment where people live defines the comfort of that environment. The elements of environmental comfort are the air quality, thermal comfort, visual comfort, and sound comfort. The air quality in the room where people stay can significantly affect their concentration, i.e., the ability to work and study. The concentration of CO 2 in the room is used as an indicator of ventilation, that is, as an indicator of the air quality in the observed room. The thermal comfort defines a state of satisfaction with the thermal environment. The thermal comfort is achieved when the environment properties are such that they ensure the release of BAKAR 48 (2023) 1 COPPER body heat within the comfortable limits. This paper presents a part of the air quality and thermal comfort measurement results in the selected office in the Mining and Metallurgy Institute Bor from 2020 to 2022. Based on the analysis of measurement results, it was determined that the air quality in the selected office was satisfactory on an average of more than 90% of the working time, and the thermal comfort on an average of about 60% of the working time.
1 January 2023 in Mining and Metallurgy Engineering Bor
This paper presents the results of measurements the suspended particles of the PM 10 and PM 2.5 fractions in two high schools in Bor (School of Mechanical and Electrical Engineering-MS and Grammar School-GM). The measurements were conducted in two heating seasons for a duration of seven days (five weekdays, and two weekend days). Periods during the weekdays when there were classes and weekend days when there were no classes at school were analyzed separately. The measurement results show that the average concentrations of suspended particles PM 10 during the class period were 1.7 (GM) and 2.4 (MS) times higher than in the period without classes. The average concentrations of suspended particles PM 2.5 in both schools during the class period were 1.5 times higher than in the period without classes. In MS the average PM 10 and PM 2.5 concentrations during classes were above daily limit values for 3 of 5 working days. In contrast, there was no exceeding of the average daily limit values for concentrations of suspended particles during classes in GM. The results of measurements indicate that more attention should be paid to the way classrooms are cleaned to reduce the possibility of particles resuspension due to the movement of pupils during the teaching period.
The results of measurements the PM10 and PM2.5 concentrations in an apartment in the town of Bor, Eastern Serbia, are presented in this paper. Measurements were made throughout 2023 using a low-cost PM monitor placed in the apartment's living room. The measurement results were categorized on the basis of several dominant activities of the tenants, namely: morning activities, cooking, cleaning and sleeping. The average annual PM10 and PM2.5 concentrations in the apartment were 8.7 g/m 3 and 5.7 g/m 3 respectively. The highest average hourly PM concentration occurred during the cleaning activity with the PM10 concentration of 61.5 g/m 3 and PM2.5 concentration of 41.5 g/m 3. The lowest average of hourly PM concentrations was recorded during the vacation period with the average PM10 concentration of 5.3 g/m 3 and average PM2.5 concentration of 4.0 g/m 3. The lowest hourly PM concentration occurred during period of sleeping with the PM10 concentration of 0.4 g/m 3 and PM2.5 concentration of 0.3 g/m 3. The presented results indicate that the activities of cleaning and morning activities are the most responsible for increase the PM concentrations in the observed apartment.
This study presents the results of seasonal variation analyses of suspended particulate matter (PM10 and PM2.5) concentrations measured in 15 residential apartments in the city of Bor, Serbia, during the period from February to June 2025. Measurements were conducted over 45-day intervals during both the heating season (February-March) and the non-heating season (May-June). The average concentrations of PM10 and PM2.5 measured indoors were compared between these two periods. During the heating season, the mean PM10 and PM2.5 concentrations were 18.2 µg/m³ and 12.0 µg/m³, respectively, while in the non-heating season, they averaged 19.5 µg/m³ and 11.1 µg/m³. The average Pearson correlation coefficients between indoor and outdoor PM10 concentrations were 0.33 in the heating season and 0.27 in the non-heating season, showing no significant seasonal difference. Similarly, the average correlation coefficients for PM2.5 concentrations were 0.51 and 0.47, respectively. The results indicate that there were no substantial seasonal variations in indoor PM concentrations, suggesting that infiltration from outdoor air remains the dominant source of indoor particulate matter. Occasional short-term increases in PM levels were observed, primarily due to cooking or particle re-suspension during cleaning activities; however, none of the recorded indoor concentrations exceeded the prescribed daily limit values for PM10 and PM2.5.