Pure water production and recovery of Ni2 + from dilute NiSO4 solution via improved electrodeionization (EDI) process were investigated. It was indicated that, with the feed water containing 50 mg L−1 Ni2 + , the dilute resistivity of the EDI could achieve 3 MΩ cm which gave a Ni2 + rejection more than 99.8% while the Ni2 + was concentrated as high as 1,583 mg L−1 in the concentrate stream. The current efficiency was as high as 40% and the concentrate factor could reach 31.7. The experiment results demonstrated that, just in a single process, it was feasible to purifying and concentrating dilute nickel wastewater synchronously by the EDI technology.
Damage evolution in concrete after high temperature is a complicated procedure, in which the pre-peak strain hardening behaviour, the post-peak strain softening behaviour and the impact of high temperature play key roles. Uniaxial and biaxial compression damage models of concrete considering high temperature degradation effect are proposed based on damage theory and experimental phenomena. They consider that the destruction of concrete is actually the cumulative evolution course of the two meso-damage modes, rupture and yield. High temperature changes the mechanical performance in microstructure of concrete and the generation and propagation of microcracks. It could be described by adjusting the probability distributions which characterize the mesoscopic damage evolution. The damage constitutive model is employed to determine the stress-strain behaviour of concrete under uniaxial compression, and the calculated results are compared with the experimental results under different high temperature levels. Results indicate that the proposed model can not only predict the stress-strain behaviour with acceptable accuracy in macroscopic scale, but also reveal the damage evolution mechanism in mesoscopic scale. Finally, the constitutive behaviour under biaxial compression is also simulated to investigate the influence of high temperature on biaxial stress-strain behavior and strength envelope.
21 February 2011 in Separation Science and Technology
The purpose of this study was to investigate the influence of resin particle size distribution on the performance of the electrodeionization (EDI) process for Ni2+ removal from synthetic wastewater. It was suggested that the stack resistance would decrease and ion transport would accelerate when packing resins with a narrow particle-size distribution in a dilute compartment. With feed water containing about 50 mg · L−1 Ni2+ at pH of 5.7, the dilute resistivity of the product stream using resins with particle size of 0.45 ∼ 0.71 mm, 0.71 ∼ 0.90 mm, 0.90 ∼ 1.25 mm, and 0.315 ∼ 1.25 mm were 0.75MΩ · cm, 1.10MΩ · cm, 0.54MΩ · cm, and 0.35MΩ · cm, respectively. For fixed-dilute spacer thickness of 3 mm, the optimum number of resin layers between membranes could be achieved and the separation performance of the EDI process was the best when using resin particles with a size of 0.71-0.90 mm. With optimum resin particle size and operating conditions, the wastewater containing nickel ions could be purified effectively and be reused by the EDI process.