The control of pneumatic soft robotics is challenging due to nonlinearites arising from many factors including pneumatic system components and material properties of the soft actuator. Manual methods for PID controller tuning are inadequate for the nonlinear and time-variant dynamics present in soft robotics. Affordable pneumatic components such as on/off valves cause discontinuities in flow rate, introducing nonlinearities and oscillatory fluctuations into the system. This study proposes a dual-loop control system: one for PID and Fractional-Order PID (FOPID) control of a solenoid valve that feeds air into the actuator, and another for PID control of the pump upstream of the valve. The PID and FOPD parameters are optimized using evolutionary algorithms: Genetic Algorithm (GA), Particle Swarm Optimization (PSO), and Simulated Annealing (SA). Simulations and real-world experiments are conducted to validate the optimized parameters. Our results demonstrate that the dual-loop hardware configuration reduces fluctuations from the valves compared with a single-loop control scheme. The experimental statistical analysis confirms that FOPID achieves the highest significant improvements in rise time (PSO) and peak time (GA, PSO), while PID performs better for overshoot (GA, PSO). These findings highlight the importance of selecting an appropriate optimization algorithm based on the specific control objective, as FOPID does not outperform PID in every metric across all methods.
The control of soft elastomeric actuators via pneumatic systems presents challenges due to system nonlinearities and oscillatory behavior. The control of soft robotics is an underexplored field compared to the control of traditional robotics. This study explores evolutionary algorithms for auto-tuning Proportional-Integral-Derivative (PID) controllers in pneumatic soft robotics. Four optimization algorithms, Genetic Algorithm (GA), Particle Swarm Optimization (PSO), Simulated Annealing (SA), and Surrogate-Based Optimization (SBO), were employed to optimize PID parameters for pneumatic pressure control. Each algorithm was tested with four objective functions: Integral Absolute Error (IAE), Integral Time Absolute Error (ITAE), Integral Square Error (ISE), and Integral Time Square Error (ITSE). Both simulated and experimental studies are conducted to evaluate these algorithms using a pneumatic system designed with affordable on/off valves controlled by Pulse Width Modulation (PWM). Key performance metrics were analyzed: rise time, settling time, overshoot, peak value, and peak time. Results indicate that PSO and GA offer faster response times and moderate overshoot, while SA provides minimal overshoot at the cost of slower response times. These findings can significantly contribute to the practical control of pneumatic systems in soft robotics, offering insights for future optimization and application development.