21 July 2020 in IEEE Transactions on Components, Packaging and Manufacturing Technology
The press-pack packaging technology has been adopted in recent years for insulated-gate bipolar transistors (IGBTs) to be utilized in high voltage – high current applications, such as high–voltage direct current (HVDC) electric power transmission. Traditionally, the heat management of such systems is based on water coolant, however, there are numerous challenges associated with that method, such as the requirement to deionize the water to prevent electrical potentials and inherent problems of corrosion and leakage in the cooling piping structure. This paper presents the design and development of a liquid metal heat sink for press–pack IGBTs. The use of a thermal management system based on liquid metal increases the heat dissipation capability without corroding the cooling structure. Analytical work is performed on the design of the heat sink. Moreover, the thermal performance of the heat sink is experimentally validated against a commercial water–based cooling system. The presented results show that the cooling performance of the liquid metal system is increased, whereas the shortcomings of the water–based system are eliminated.
18 January 2021 in IEEE Transactions on Components, Packaging and Manufacturing Technology
Press-pack insulated gate bipolar transistors (PP-IGBTs) are commonly connected in series and stacked together with heatsinks using an exterior clamping fixture in order to achieve high-voltage dc-link levels. A suitable contact area between the clamping fixture and the device is essential to ensuring optimal PP-IGBT thermomechanical performance, especially for the first and last devices in a stack. In this study, the effects of the clamping area on collector deformation, temperature, and stress distributions are investigated by means of the finite-element method (FEM). Moreover, this article analyzes the influence of heatsink thickness to maximize the stress evenness of the terminal PP-IGBT and reduce the overall length of the stack system. The results indicate that the collector lid is prone to warpage due to thermal expansion, which results in a decrease in the effective contact area between component layers. As the contact resistance increases, the chips accumulate considerable heat. Increasing the clamping area at this point can adequately compensate for the warp deformation and can also improve the stress uniformity of the chips. Finally, an experiment making use of stress-sensitive film has been carried out to verify the developed FEM models.
28 July 2021 in IEEE Journal of Emerging and Selected Topics in Power Electronics
The electrical contact status between metal layers in a Press Pack Injection Enhanced Gate Transistor (PP-IEGT) is essential information for the reliability of the whole device. This paper employs the numerical method, microscopic detection, and power cycle test (PCT) to qualify the contact degradations and performance in PP-IEGT. Firstly, the contact status of metal pair aluminum-molybdenum in a single-chip module is described through the finite element method (FEM). Then, the contact fatigue of the single-chip module is estimated by the micro-detection of chip surface and the monitor of contact resistance during PCT. Finally, PCTs are conducted on parallel branches to explore the contact degradation under different contact statuses. The results show that the chip is subjected to fretting wear and cracks due to the periodic expansion and shrink. In the aging process, the contact resistances display a linear growth trend and have a significant impact on the electrical parameter shift. Moreover, the degradation of the branch with insufficient contact is more serious, especially under smaller clamping force and longer heating duration.