The on-off optical gain measurements as a function of the pump power were performed on porous silicon planar waveguides codoped by erbium and ytterbium ions. These measurements were obtained for different ratios of Yb concentration to Er concentration. The highest value of the gain was reached when the Yb concentration is three times higher than that of Er at a moderate pump power value equal to . Optical losses measurements have been performed on these waveguides and were equal to and an internal gain of about was obtained.
Planar waveguides made of Nd3+-doped silicon rich silicon oxide (SRSO) and silicon rich silicon nitride (SRSN) have been fabricated by reactive magnetron sputtering and characterized with special emphasis on the comparison of the guided photoluminescence (PL) properties of these two matrices. Guided fluorescence excited by top surface pumping at 488 nm on planar waveguides was measured as a function of the distance between the excitation area and the output of the waveguide, as well as a function of the pump power density. The PL intensity increased linearly with pump power without any saturation even at high power. The linear intensity increase of the Nd3+ guided PL under a non-resonant excitation (488 nm) confirms the efficient coupling between either Si-np and rare-earth ions for SRSO or radiative defects and rare earth ions for SRSN. The guided fluorescences at 945 and 1100 nm were observed until 4 mm and 8 mm of the output of the waveguide for Nd3+ doped SRSO and SRSN waveguides, respectively. The guided fluorescence decays of Nd3+-doped-SRSO and -SRSN planar waveguides have been measured and found equal to 97 μs ±7 and 5 μs ± 2, respectively. These results show notably that the Nd3+-doped silicon rich silicon oxide is a very promising candidate on the way to achieve a laser cavity at 1.06 μm.
We present a butt-coupled InGaN fiber Bragg grating (FBG) semiconductor laser diode operating below 400 nm in the single-mode emission regime. This compact coherent laser source exhibits an intrinsic linewidth of 14 kHz in the near-UV range and a side-mode suppression ratio reaching up to 40 dB accompanied by almost 2 mW output power. Furthermore, the properties of the FBG, including its central wavelength, bandwidth, and reflectivity, can be readily customized to fulfill specific requirements. As a result, the small footprint design of this laser is compatible with integration into a standard butterfly package to ease the lab-to-market technology transfer. The combination of low-frequency noise and fibered output signal positions these FBG laser systems as strong candidates for hybridization with integrated photonic platforms tailored for quantum information processing and metrology.
25 July 2008 in IEEE Journal of Quantum Electronics
We investigate the modal properties, for TE polarization, of graded-index porous silicon slab waveguides with linearly varying dielectric permittivity. Using transfer matrix formalism, we derive all-analytical expressions, in terms of special functions of the Bessel class, for the propagation constant and the transverse profile of each mode.