Marc Schneebeli

Marc Schneebeli

Auto-generated profile, based on publicly available information

Marc Schneebeli

Palindrome Remote Sensing, Landquart, Switzerland

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
28 February 2024 in IEEE Geoscience and Remote Sensing Letters
Verified
Journal Article
Closed access
DSDavid Schvartzman
David Schvartzman
DZDusan Zrnic
Dusan Zrnic
Boonleng CheongBoonleng Cheong
Boonleng Cheong
ASAntonio R. Segales
Antonio R. Segales
MSMarc Schneebeli
Marc Schneebeli
A measurement procedure to determine transmitted differential phase between horizontally and vertically polarized radiation of a dual-polarization radar is presented. It is applicable to radars that transmit and receive Simultaneously Horizontally and Vertically (SHV) polarized waves. The method relies only on power measurements and leverages capabilities of polarimetric radars with independent transmitters per polarization to estimate differential phase on transmission. Measurements using this method by ground and airborne systems are conducted, and results are validated using a software-defined radio that provides true phase measurements. The differential phase estimate produced with the proposed method for the PX-1000 (X-band) radar is -105°, while that produced with the software-defined radio is -104.47° ±4.43°. The proposed method with a simple power sensor achieves a precision of ±2.5°.

8 October 2025 in Atmospheric Measurement Techniques
Verified
Journal Article
Open access
PDF file
MSMarc Schneebeli
Marc Schneebeli
ALAndreas Leuenberger
Andreas Leuenberger
PSPhilipp J. Schmid
Philipp J. Schmid
JGJacopo Grazioli
Jacopo Grazioli
HCHeather Corden
Heather Corden
VCV. Chandrasekar
V. Chandrasekar
We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and SPLASH (its mobile version) from CSU and EPFL's new solid-state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, remarkable precision and stability were found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a 1 h time series. Calibration issues that arise with solid-state radar systems were investigated with experiments conducted with the EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz, and consequently calibration targets were generated independently for the two channels. Excellent stability and accuracy were found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyzes a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggest that precise absolute and differential calibrations can be achieved if data are obtained in an environment free from multipaths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.

5 July 2025
Verified
Other
Open access
PDF file
MSMarc Schneebeli
Marc Schneebeli
ALAndreas Leuenberger
Andreas Leuenberger
PSPhilipp J. Schmid
Philipp J. Schmid
JGJacopo Grazioli
Jacopo Grazioli
HCHeather Corden
Heather Corden
VCV. Chandrasekar
V. Chandrasekar
We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and its mobile version SPLASH from CSU and EPFL's new solid state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, a remarkable precision and stability was found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a one-hour time series. Calibration issues that arise with solid state radar systems were investigated with experiments conducted with EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz and consequently calibration targets were generated independently for the two channels. An excellent stability and accuracy was found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyses a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggests that precise absolute and differential calibrations can be achieved if data is obtained in an environment free from multi-paths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.

13 May 2025
Verified
Other
Open access
PDF file
MSMarc Schneebeli
Marc Schneebeli
ALAndreas Leuenberger
Andreas Leuenberger
PSPhilipp J. Schmid
Philipp J. Schmid
JGJacopo Grazioli
Jacopo Grazioli
HCHeather Corden
Heather Corden
VCV. Chandrasekar
V. Chandrasekar
We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and its mobile version SPLASH from CSU and EPFL's new solid state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, a remarkable precision and stability was found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a one-hour time series. Calibration issues that arise with solid state radar systems were investigated with experiments conducted with EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz and consequently calibration targets were generated independently for the two channels. An excellent stability and accuracy was found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyses a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggests that precise absolute and differential calibrations can be achieved if data is obtained in an environment free from multi-paths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.

2 June 2025
Verified
Other
Open access
PDF file
MSMarc Schneebeli
Marc Schneebeli
ALAndreas Leuenberger
Andreas Leuenberger
PSPhilipp J. Schmid
Philipp J. Schmid
JGJacopo Grazioli
Jacopo Grazioli
HCHeather Corden
Heather Corden
VCV. Chandrasekar
V. Chandrasekar
We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and its mobile version SPLASH from CSU and EPFL's new solid state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, a remarkable precision and stability was found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a one-hour time series. Calibration issues that arise with solid state radar systems were investigated with experiments conducted with EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz and consequently calibration targets were generated independently for the two channels. An excellent stability and accuracy was found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyses a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggests that precise absolute and differential calibrations can be achieved if data is obtained in an environment free from multi-paths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.

24 April 2025 in EGUsphere
Verified
Preprint
Open access
PDF file
MSMarc Schneebeli
Marc Schneebeli
ALAndreas Leuenberger
Andreas Leuenberger
PSPhilipp J. Schmid
Philipp J. Schmid
JGJacopo Grazioli
Jacopo Grazioli
HCHeather Corden
Heather Corden
VCV. Chandrasekar
V. Chandrasekar
We present findings from radar calibration experiments involving three radars operated by the Colorado State University (CSU) in the US and by the École Polytechnique Fédérale de Lausanne (EPFL) in Switzerland. The experiments were based on the comparison between measured radar variables and the known properties of artificial point targets electronically generated with a polarimetric radar target simulator (RTS) from Palindrome Remote Sensing. Radars under test included the two magnetron-based radars CHILL and its mobile version SPLASH from CSU and EPFL's new solid state radar StXPol. For the CHILL and SPLASH calibration measurements in Colorado, a mobile lifting platform was employed that elevated the target simulator instrument to approximately 15 m above ground. The creation of virtual targets with polarimetric signatures allowed for a direct calibration of polarimetric variables. While the SPLASH radar exhibited good Zdr and sufficient Zh accuracy, a remarkable precision and stability was found in CHILL's reflectivity data time series, where the reflectivity bias compared to the virtual target was less than 0.2 dB over a one-hour time series. Calibration issues that arise with solid state radar systems were investigated with experiments conducted with EPFL StXPol radar. This pulse compression system transmits a linear frequency-modulated long pulse as well as a non-modulated short pulse for observations at close ranges. The two pulses are separated in frequency by 50 MHz and consequently calibration targets were generated independently for the two channels. An excellent stability and accuracy was found for Zdr in both channels. While Zh stability was also very high, a large reflectivity bias in both the long and the short pulse channel was detected. For the first time, the article introduces and analyses a weather radar calibration procedure that is based on electronically generated radar targets. Experimental data suggests that precise absolute and differential calibrations can be achieved if data is obtained in an environment free from multi-paths and if the generated targets are precisely located in the center of the radar's range gate. Experimental shortcomings associated with limited sampling resolution of the radar scan over the targets are also investigated.