The influence of liquid conductivity on electrical breakdown and hydrogen peroxide (H 2 O 2 ) production in a nanosecond pulsed filamentary discharge generated in a water film plasma reactor was investigated over the liquid conductivity range from 0.01 mS cm −1 to 36 mS cm −1 by adding KCl to deionized (DI) water and using helium and argon as carrier gases. The plasma properties, including electron density, gas temperature, and plasma volume, the H 2 O 2 production rate and energy yield, and the energy dissipation into the liquid were determined at different liquid conductivity. The energy dissipation into the bulk liquid increased as the liquid conductivity increased causing the total input energy to increase and resulting in a small decrease in H 2 O 2 energy yield. In addition, the production rate of H 2 O 2 did not change significantly with conductivity for the helium plasma but decreased about 13 percent in the argon plasma. The energy deposited in the helium plasma did not change with conductivity, thereby causing the H 2 O 2 energy yield based upon energy in the plasma to be constant with conductivity. A model based upon the electrical circuit was used to predict the breakdown voltage for a range of liquid conductivity up to 36 mS cm −1 . This model also showed that decreasing the rise time of the applied voltage (i.e. faster rising rate) significantly increased the breakdown voltage, and therefore improved the liquid conductivity tolerance of the plasma system allowing it to function at near sea-water conductivity.
18 January 2023 in Reviews of Modern Plasma Physics
The influence of carrier gas (argon and helium) on the properties of a nanosecond pulsed filamentary discharge propagating along the water surface in a water film plasma reactor, and the effects of plasma properties on the formation of hydrogen peroxide (H 2 O 2 ) are investigated. The plasma properties, including electron density, gas temperature, and plasma volume, and the hydrogen peroxide production rate and energy yield were measured and compared in both argon and helium discharges. The results show that helium plasma is more diffusive compared with the argon plasma, and it has lower electron density and gas temperature but larger volume. The production rates and energy yields of hydrogen peroxide are only slightly higher in the helium plasma although the electron density is much lower. A simple mathematical model with time-dependent fast radical and electron quenching in a small film surrounding the plasma core and with lumped reaction kinetics for H 2 O 2 formation and degradation suggests that the hydroxyl radical (·OH) concentration is approximately two times higher in the argon discharge, but the larger volume of the helium leads to about two times more total ·OH in the helium with correspondingly higher energy yields. The experimental data and model imply that the H 2 O 2 energy yield may increase at lower power (or specific energy density) for both carrier gases.