Traffic congestion has become a problem in the central business district of Akure. These roads during peak periods have defied measures to alleviate such congestion, leading to poor mobility and economic losses in form of costs of fuel, oil, as well as time cost of road users. The field survey was conducted on two major roads in the Central Business District (CBD) namely Oba Adesida and Arakale roads while considering the two directions along each route namely directions A and B, C and D respectively. Traffic parameters such as flow rate, speed and density were analyzed from the traffic data collected from each route along each direction. The field survey was carried out for a week (from Monday to Sunday) during the peak periods.ÂÂÂÂ The speed along direction A of Oba Adesida road was low due to more vehicles traversing the route. However, the speed of vehicles along direction D of Arakale road was lower than that along direction C. The traffic parameters were plotted against each other for the four directions for the morning, afternoon and evening periods. The derived linear models (equations) along the four directions gave minimum speeds for morning, afternoon and evening of 33.64 km/hr, 33.65 km/hr and 30.71km/hr respectively along direction A and 30.94 km/hr, 31.80 km/hr and 31.88 km/hr respectively along direction B for Oba-Adesida road; 36.59 km/hr , 35.30 km/hr, 33.58 km/hr respectively along direction C and 35.25 km/hr, 34.75 km/hr and 34.07 km/hr respectively along direction D for Arakale road for no congestion to occur.
The aim of this research is to evaluate the rheological properties of industrial waste modified bitumen. The varying proportion of polypropylene ranging from 0% to 20% of the weight of bitumen at 5% interval with 60/70 penetration grade was used. The asphalt binder modification was prepared by using high-speed mixer at temperature from 150 °C to 190 °C. The conventional test like softening point, penetration, ductility, flash and fire point test were carried out to assess the physical characteristics of polypropylene modified and unmodified bitumen, thereafter dynamic shear rheometer and rotational viscosity test were conducted to determine the rheological properties of bitumen. The result indicated that polypropylene has ability to improve the conventional properties of bitumen by increased penetration and ductility, decrease softening point and flash and fire point. Polypropylene modified bitumen provides better resistance against permanent deformation due to their increase in complex modulus and rotational viscosity and decrease in phase angle. It can be concluded that polypropylene modified bitumen could improve the level of performance and service life of the road.
This study evaluates the influence of sawdust ash, glass powder and rice husk ash as admixtures for partially replacing fine aggregate in concrete for rigid pavement applications. Compressive strength tests were conducted at 5%, 10%, 15%, and 20% replacement levels. Rice husk ash achieved the highest compressive strength of 10.40 N/mm2 at 10% replacement after 28 days, closest to the control. However, sawdust ash and glass powder exhibited reduced strengths as replacement levels increased. The maximum compressive strength obtained did not meet the required target for rigid pavement applications.
This study investigates the geotechnical properties of lateritic soil stabilized with pulverized wood charcoal (PWC) in comparison with the same soil stabilized with cement which is considered to be the best stabilizer. Classification of the soil according to AASHTO revealed that the soil is an A-6 soil. Chemical tests carried out on PWC and ordinary Portland cement (OPC) indicated that the major oxides present in the OPC sample were CaO and SiO2 at 60.50% and 21.40% respectively and in the PWC were CaO and SiO2 at 39.46% and 28.46% respectively. This distinctly high concentration of CaO is responsible for their high stabilizing property. Compaction, California Bearing Ratio (CBR) and Unconfined Compressive Strength (UCS) tests carried out on the lateritic soil in its natural state and when PWC was added in varying proportions of 2, 4, 6, 8 and 10% by weight of soil indicated that the stabilizer enhanced the strength of the lateritic soil. The unsoaked CBR value of the soil attained the optimum value of 13.68% on addition of 6% PWC by weight of soil. The unconfined compressive strength improved from 148.65kN/m2 in the natural state to 296.6kN/m2 at 10% PWC addition. Based on the geotechnical properties obtained, charcoal has a high potential of being a veritable soil stabilizer and compares favourably with cement in compressive strength.
This study investigates the geotechnical properties of lateritic soil stabilized with pulverized wood charcoal (PWC) in comparison with the same soil stabilized with cement which is considered to be the best stabilizer. Classification of the soil according to AASHTO revealed that the soil is an A-6 soil. Chemical tests carried out on PWC and ordinary Portland cement (OPC) indicated that the major oxides present in the OPC sample were CaO and SiO2 at 60.50% and 21.40% respectively and in the PWC were CaO and SiO2 at 39.46% and 28.46% respectively. This distinctly high concentration of CaO is responsible for their high stabilizing property. Compaction, California Bearing Ratio (CBR) and Unconfined Compressive Strength (UCS) tests carried out on the lateritic soil in its natural state and when PWC was added in varying proportions of 2, 4, 6, 8 and 10% by weight of soil indicated that the stabilizer enhanced the strength of the lateritic soil. The unsoaked CBR value of the soil attained the optimum value of 13.68% on addition of 6% PWC by weight of soil. The unconfined compressive strength improved from 148.65kN/m2 in the natural state to 296.6kN/m2 at 10% PWC addition. Based on the geotechnical properties obtained, charcoal has a high potential of being a veritable soil stabilizer and compares favourably with cement in compressive strength.