1 October 2022 in Scientific and Technical Journal of Information Technologies, Mechanics and Optics
The results of the study of the optical properties of low-density InGaPAs quantum dots, as well as the effect of low temperatures and thermal annealing parameters on their optical and structural properties were presented. InGaPAs quantum dots were formed by substituting phosphorus with arsenic in InGaP layer directly during epitaxial growth. The optical properties of InGaPAs quantum dots were studied by photoluminescence (PL) spectroscopy. Photoluminescence spectra at liquid nitrogen temperature (–196 °С) made it possible to determine the features of nonradiative recombination in heterostructures. The heterostructures were subjected to short-term thermal annealing at temperatures of 600 and 650 °C for 2 min to estimate the effect of annealing on the optical and structural properties of quantum dots. It was shown that at –196 °С the contribution of nonradiative recombination can be considered insignificant for the entire measured range of pumping power rage but at temperatures above –73 °С, the contribution of nonradiative Shockley-Reed recombination can be observed. Rapid thermal annealing of InGaPAs quantum dots led to reduce the number of point defects and growth of PL intensity. InGaPAs quantum dots and substitution method can find their application in the creation of single photon sources. The presented experimental results should be considered for implementing such sources, especially for optimizing the width and intensity of the radiation line.
12 October 2023 in Kondensirovannye sredy i mezhfaznye granitsy = Condensed Matter and Interphases
At the moment, InGaN ternary compounds are of a great interest for the development of devices for sunlight driven water splitting. However, the synthesis of such materials is hindered by the fact that InxGa1–xN layers are susceptible to phase decomposition at x from 20 to 80%. Nanowires can be a promising solution to this problem. The purpose of our study was to analyze the structural and optical properties of InxGa1–xN nanowires with a gradient x content being inside the miscibility gap. InxGa1–xN nanowires were grown on silicon substrates using plasma-assisted molecular beam epitaxy. The structural properties of nanowires were studied using scanning and transmission electron microscopy. The chemical composition and optical properties of nanowires were analyzed using energy-dispersive microanalysis and photoluminescence spectroscopy. It was shown for the first time that the composition-graded InxGa1–xN nanowires with x from 40 to 60% can be grown using plasma-assisted molecular beam epitaxy. The grown samples exhibit photoluminescence at room temperature with a maximum at about 890 nm, which corresponds to an In content of about 62% according to the modified Vegard’s rule and the transmission electron microscopy data. The obtained results can be of practical interest for the development of devices for water splitting induced by sunlight or sources of near IR radiation
3 October 2026 in SSRN Electronic Journal
We report high-efficiency and compact semiconductor microcavity lasers with limaçon-shaped geometry operating in continuous-wave mode. The lasers, with radii (r0) ranging from 10 to 25 μm, were formed using a p-i-n heterostructure with an active region based on high-density InGaAs/GaAs quantum dot array, emit at a wavelength near 1080 nm at room temperature. Using smooth cavity deformation with a deformation factor up to ε = 0.46, we achieved directional emission output in the plane of the cavity. Single-mode lasing with an output power of up to 2 mW, limited by the laser self-heating effect, is demonstrated for a laser with a radius of r0 = 10 μm. For larger lasers (r0 = 25 μm), operating in multimode regime, an output power reaches 10 mW. The resonator maintains a high Q of 2×10^(6), enabling a laser linewidth of 150 MHz. The obtained results demonstrate the potential of such microlasers as highly stable and energy-efficient radiation sources suitable for integration into modern photonic circuits.