18 August 2016 in Review of Scientific Instruments
A two-crystal assembly was deployed on the tangential X-ray crystal spectrometer to measure both helium-like and hydrogen-like spectra on EAST. High-quality helium-like and hydrogen-like spectra were observed simultaneously for the first time on one detector for a wide range of plasma parameters. Profiles of line-integrated core ion temperatures inferred from two spectra were consistent. Since tungsten was adopted as the upper divertor material, one tungsten line (W XLIV at 4.017 Å) on the short-wavelength side of the Lyman-α line (Lα1) was identified for typical USN discharges, which was diffracted by a He-like crystal (2d = 4.913 Å). Another possible Fe XXV line (1.85 Å) was observed to be located on the long-wavelength side of resonance line (w), which was diffracted from a H-like crystal (2d = 4.5622 Å) on the second order. Be-like argon lines were also observable that fill the detector space between the He-like and H-like spectra.
15 April 2019 in Nuclear Fusion
1 September 2019 in Review of Scientific Instruments
A bulk charge exchange spectroscopy system has been applied to measure the radial profiles of the hydrogen (H) and deuterium (D) density ratio in the isotope mixture plasma in a large helical device. Charge exchange lines of Hα and Dα are fitted by 4 Gaussian of H and D cold components and H and D hot components with 5 parameters by combining the measurement of plasma toroidal rotation velocity with carbon charge exchange spectroscopy. The radial profiles of the relative density of hydrogen and deuterium ions are derived from H and D hot components measured and the beam density calculated from beam attenuation calculation. A proof-of-principle experiment is performed by the H pellet and the D pellet injections into the H-D mixture plasma.
1 April 2019 in Physics Letters A
1 February 2020 in Physics of Plasmas
RF-heated H-mode plasmas are readily achieved with lower hybrid current drive and ICRF heating on experimental advanced superconducting tokamak (EAST). Characteristics of H-mode plasma rotation are studied, including the behaviors for non-stationary and stationary H-mode discharges. Experimental results indicate that substantial co-current core rotation increment is observed at L-H transition. For non-stationary discharges with multiple L-H transitions, central plasma rotation varies as the plasma enters and exits the H-mode phase. Rotation increase over L-H transition is linearly correlated with plasma stored energy for both edge localized mode (ELM)-free phases and phases with type-III ELMs. For stationary H-mode discharges with type-III ELMs, core plasma rotation profile is elevated and remains stable during the H-mode phase, although the occurrence of ELMs tends to slow down the core rotation, especially for type-I ELMs where the entire core profiles are affected. Evolution of plasma rotation is fitted with a source-free transport equation and it is found that the momentum transport is dominated by diffusion and explains the flat profile in the core. Based on the Rice scaling and for the same stored energy increase, smaller increase in the core rotation is observed for H-mode discharges with type-III ELMs than for ELM-free discharges. A linear fit indicates that the slope is 75% larger for the ELM-free discharges data.
1 June 2021 in Review of Scientific Instruments
A bulk charge exchange spectroscopy (BCXS) system using a grism (grating prism) spectrometer has been applied to measure the profile of the deuterium (D) fraction in deuterium and hydrogen (H) mixture plasma in the Large Helical Device. The observed spectrum can be fitted with four Gaussian functions successfully by reduction of free parameters for the least-squares fit. The plasma flow velocity and ion temperature profile measured by charge exchange spectroscopy using carbon impurity are used for estimation of the wavelength shift of hot components to reduce the free parameter. The ion temperature is used to estimate the apparent wavelength shift due to the energy dependent emission cross section only and is not used to set the Doppler width for H and D in the fitting. The sensitivity of the evaluated D fraction on the velocity is increased for a higher D fraction. The error of the D fraction is calculated from the error in the fitted parameter and sensitivity on the velocity of the hot component. The difference in the profile and time trace of the D fraction with D pellet and H pellet injection was observed clearly by BCXS using a grism spectrometer.