1 May 2003 in Computer Methods in Biomechanics and Biomedical Engineering
A model of muscle energy expenditure was developed for predicting thermal, as well as mechanical energy liberation during simulated muscle contractions. The model was designed to yield energy (heat and work) rate predictions appropriate for human skeletal muscle contracting at normal body temperature. The basic form of the present model is similar to many previous models of muscle energy expenditure, but parameter values were based almost entirely on mammalian muscle data, with preference given to human data where possible. Nonlinear phenomena associated with submaximal activation were also incorporated. The muscle energy model was evaluated at varying levels of complexity, ranging from simulated contractions of isolated muscle, to simulations of whole body locomotion. In all cases, acceptable agreement was found between simulated and experimental energy liberation. The present model should be useful in future studies of the energetics of human movement using forward dynamic computer simulation.
31 March 2010 in Journal of The Royal Society Interface
Leg swing in human walking has historically been viewed as a passive motion with little metabolic cost. Recent estimates of leg swing costs are equivocal, covering a range from 10 to 33 per cent of the net cost of walking. There has also been a debate as to whether the periods of double-limb support during the stance phase dominate the cost of walking. Part of this uncertainty is because of our inability to measure metabolic energy consumption in individual muscles during locomotion. Therefore, the purpose of this study was to investigate the metabolic cost of walking using a modelling approach that allowed instantaneous energy consumption rates in individual muscles to be estimated over the full gait cycle. At a typical walking speed and stride rate, leg swing represented 29 per cent of the total muscular cost. During the stance phase, the double-limb and single-limb support periods accounted for 27 and 44 per cent of the total cost, respectively. Performing step-to-step transitions, which encompasses more than just the double-support periods, represented 37 per cent of the total cost of walking. Increasing stride rate at a constant speed led to greater double-limb support costs, lower swing phase costs and no change in single-limb support costs. Together, these results provide unique insight as to how metabolic energy is expended over the human gait cycle.
1 January 2008 in Journal of Orthopaedic & Sports Physical Therapy
Cross-sectional. To determine if females presenting with patellofemoral pain syndrome (PFPS) from no discernable cause other than overuse demonstrate hip weakness and increased hip internal rotation, hip adduction, and knee valgus during stair descent. Historically, PFPS has been viewed exclusively as a knee problem. Recent findings have indicated an association between hip weakness and PFPS. Researchers have hypothesized that patients who demonstrate hip weakness would exhibit increased hip internal rotation, hip adduction, and knee valgus during functional activities. To date, researchers have not simultaneously examined hip and knee strength and kinematics in subjects with PFPS to make this determination. Eighteen females diagnosed with PFPS and 18 matched controls participated. Strength measures were taken for the hip external rotators and hip abductors. Hip and knee kinematics were collected as subjects completed a standardized stair-stepping task. Independent t tests were used to determine between-group differences in strength and kinematics during stair descent. Subjects with PFPS generated 24% less hip external rotator (P = .002) and 26% less hip abductor (P =. 006) torque. No between-group differences (P > .05) were found for average hip and knee transverse and frontal plane angles during stair descent. Subjects with PFPS had significant hip weakness but did not demonstrate altered hip and knee kinematics as previously theorized. Additional investigations are needed to better understand the association between hip weakness and PFPS etiology.
15 September 2007 in Journal of Experimental Biology
SUMMARY: Walking humans prefer to use the stride rate that results in the lowest rate of metabolic energy expenditure. Mechanical power requirements have been suggested to underlie the metabolic response, but mechanical power is consistently reported to be minimal at stride rates 20–30% lower than preferred. This may be due to limitations in how total mechanical power has been computed, as well as a failure to account for the efficiency with which muscular work is done. We investigated how mechanical power and efficiency depend on stride rate in walking, with both quantities computed from the work done by the hip, knee and ankle joint moments. Our hypotheses were that mechanical power and efficiency are both optimized at the preferred stride rate, which would explain why metabolic energy expenditure is minimized at this rate. Contrary to our hypotheses, mechanical power curves exhibited plateaus that spanned stride rates lower than preferred (predicted optima:11–12% below preferred), while net mechanical efficiency exhibited a plateau that spanned stride rates higher than preferred (predicted optimum: 8%above preferred). As expected, preferred stride rate (54.3 strides min–1) was not different from the stride rate that minimized net metabolic energy expenditure (predicted optimum: 0.2% above preferred). Given that mechanical power and mechanical efficiency exhibited plateaus on opposite sides of the preferred stride rate, the preferred rate in walking likely represents a compromise between these two factors. This may also explain the relative flatness of the curve for metabolic rate in the vicinity of the preferred stride rate.
1 August 2008 in Journal of Biomechanics
9 November 2011 in Proceedings Of The Royal Society B-Biological Sciences
A popular hypothesis for human running is that gait mechanics and muscular activity are optimized in order to minimize the cost of transport (CoT). Humans running at any particular speed appear to naturally select a stride length that maintains a low CoT when compared with other possible stride lengths. However, it is unknown if the nervous system prioritizes the CoT itself for minimization, or if some other quantity is minimized and a low CoT is a consequential effect. To address this question, we generated predictive computer simulations of running using an anatomically inspired musculoskeletal model and compared the results with data collected from human runners. Three simulations were generated by minimizing the CoT, the total muscle activation or the total muscle stress, respectively. While all the simulations qualitatively resembled real human running, minimizing activation predicted the most realistic joint angles and timing of muscular activity. While minimizing the CoT naturally predicted the lowest CoT, minimizing activation predicted a more realistic CoT in comparison with the experimental mean. The results suggest a potential control strategy centred on muscle activation for economical running.