Department of Structural Mechanics, Faculty of Civil Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., Budapest, H-1111, Hungary
Auto-generated profile, based on publicly available information
Róbert Károly Németh
Department of Structural Mechanics, Faculty of Civil Engineering, Budapest University of Technology and Economics, Műegyetem rkp. 3., Budapest, H-1111, Hungary
Modal analysis is an often-used method for the solution of dynamical problems in engineering practice. In the case of continuous systems and discretization methods (e.g., FEM) with a large number of degrees of freedom, the reduced modal analysis is used, where only a selected number of modes are applied, while the higher modes are neglected. A piecewise linear elastic structure has state-dependent stiffness and as such, state-dependent vibration modes. During the dynamic modal analysis of such systems, one has to switch between the modes. During the switch a part of the kinetic and potential energy is transferring into modes, which are neglected in the reduced modal analysis. Thus, using the reduced modal analysis for the numerical calculation of the dynamic behavior of piecewise linear elastic structures introduces the modal truncation damping. In this paper, we present on a continuous system, how this modal truncation damping can be characterized, what are the upper and lower limits of that damping and how the characteristics of the free vibration of a piecewise linear elastic structure can be predicted.
12 July 2018 in International Journal of Architectural Heritage
Historically, the first groin vaults were built without ribs, but ribs later appeared for various reasons. Some ribs have only an aesthetic role, while others have a clear structural role in stiffening the groin. The stiffening effect on the static behavior is currently of wide interest, as the preservation of architectural heritage has become important. While static behavior has various explanations, the discrete spatial structure of cross vaults allowed for only approximate solutions to dynamic problems, such as seismic load response. In this article, a 3D time-history analysis is carried out with a commercial discrete element code. Following the motion of elastic discrete blocks in the structure allows the continuation of nonlinear effects from the rocking and sliding of the blocks. The analysis only addresses the most presumably dangerous direction of ground acceleration. The time-history analysis uses a synthetic accelerogram; a real accelerogram is scaled in the frequency domain to fit to a standard response spectrum. The influence of the supporting walls is handled approximately by considering them to be an SDoF system, which affects the signal of the support acceleration.
1 December 2010 in International Journal of Bifurcation and Chaos