Ternary master alloys Al-Sc-Zr, Al-Sc-Ti, and Al-Ti-Zr are prepared. The complex aluminides Al3(ScxZr1−x), Al3(ScxTi1−x), and Al3(TixZr1−x) in them have the L12 cubic lattice, which ensures high structural and size matching with the crystal lattice of the matrix of the aluminum alloys modified by these master alloys. The action of low-frequency vibrations on the melts of the ternary master alloys favors the fragmentation of the aluminides down to sizes smaller than 10–30 μm and their uniform distribution in an alloy matrix.
The standard enthalpies of formation of intermetallic compounds in the Al-Sc system are calculated using a well-known semiempirical model. The determined values agree satisfactorily with the most reliable experimental data. The thermodynamic simulation made it possible to calculate the equilibrium characteristics for Al-Sc liquid alloys in the temperature range from 1873 to 2073 K.
Thermal decomposition of copper digallide was studied using experimental (thermal analysis) and theoretical (thermodynamic modeling) methods. The temperatures of CuGa2 incongruent melting are in satisfactory agreement between experimental and calculated values. Small differences with the phase diagram can be explained by minor non-stoichiometry of the alloy samples. The experimental studies of thermal diffusivity and thermal expansion of CuGa2 were performed in the temperature range 298-500 K. The heat conductivity coefficient was further calculated using literary data concerning the density and heat capacity of the copper digallide.
The effects of the composition of ternary Al-Ti-Zr master alloys, the overheating of their melts with respect to liquidus, and exposure to low-frequency vibrations on the structure formation in them are studied. It is shown that complex aluminide Al3(ZrxTi1 − x) with a metastable L12-type cubic lattice coinciding with the structure type of α Al primarily precipitates during the crystallization of Al-Ti-Zr melts under certain conditions. This fact makes such master alloys promising for modifying aluminum alloys.
An Al-1.1 Sc-1.1 Zr (wt %) master alloy with a uniform distribution of micron and submicron particles of aluminide phase Al3(Sc1 − xZrx) has been obtained by exposing of equal amounts of commercial Al-Sc and Al-Zr master alloys to short-time actions of low-frequency vibrations transferred to the alloy via an irradiating plunger. Zirconium substitutes up to 50% Sc in aluminides and retains its L12 lattice. The modifying capacity of the experimental master alloy is tested on cast alloy (wt %) Al-8Zn-2.4Cu-3Mg. Intense grain refinement of this alloy is achieved by its modification with a certain amount of the master alloy. At a certain Sc + Zr content, a grain dendrite structure completely disappears in the alloy.