Haowei Wang

Haowei Wang

Auto-generated profile, based on publicly available information

Haowei Wang

Aviation Key Laboratory of Science and Technology on Structural Corrosion Protection and Control, China Special Aircraft Research Institute 3 , Jingmen, China

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2023 in Review of Scientific Instruments
Verified
Journal Article
Open access
PDF file
YCYuxiong Cai
Yuxiong Cai
XWXuanze Wang
Xuanze Wang
XYXin Yu
Xin Yu
HZHang Zhao
Hang Zhao
ZZZhongsheng Zhai
Zhongsheng Zhai
HWHaowei Wang
Haowei Wang
In an auto-balancing bridge for high impedance measurements, an operational amplifier (Op-Amp) is used to follow the intermediate potential. However, the input impedance of the Op-Amp introduces significant effects in high impedance measurements. This paper proposes a two-step excitation method (TSEM) and an incremental iterative method (IIM). The TSEM determines the magnitude of the Op-Amp input impedance and the initial value of the device under test. The IIM utilizes the TSEM results as initial conditions to quickly bring the bridge to equilibrium. To overcome the distortion issues associated with small amplitude excitation signals generated by the DAC under low resolution conditions, a programmable gain amplifier is designed. Additionally, a half-cycle difference algorithm is developed prior to the three-parameter sine fit to mitigate low-frequency direct-current drift caused by power frequency, thus improving measurement accuracy. Experimental results demonstrate that when the reference impedance is set to 1 MΩ, impedance measurements ranging from 1 kΩ to 100 MΩ can be achieved within the frequency range of 1 to 100 kHz. The precision evaluation reveals a relative standard deviation (RSD) of the modulus better than 0.384% and a standard deviation (SD) of the phase angle better than 3.49 mrad; especially for the impedance under test of 1 MΩ, the RSD is better than 0.006% and the SD is better than 0.1 mrad.