This research aimed to improve the mechanical properties of NiCrMo alloyed steel casting, especially in terms of toughness. Toughness is a combination of tensile strength, yield strength, and elongation. The method used was a multi-heat treatment process involves normalizing, tempering, double tempering, and an additional intermediate process of quenching. The results obtained through the normalizing process followed by single quenching on oil media and double tempering (single quenching double tempering) produced the best-combined result of tensile strength, yield strength, and elongation. The modulus of toughness increased by up to 745 % compared to the as-cast condition from 20 N.mm/mm3 to 149 N.mm/mm3. The best mechanical properties were obtained from tempered martensite microstructure. It is free from rest martensite and secondary carbide.
During a forming process of steel plate microstructural changes occurs in the material. The outside part of the material experiences tension while compression stress takes place in the inner side. Constant uniaxial load, speed and temperature were applied on the V bending of 4 mm thick low carbon steel plate. Microstructural observation and hardness test were carried out on the cross-section area of the plate to assess the changes within the material. It is revealed that an offset of the imaginary neutral line to the inner side has occurred. The elongation of stretched material on the outer side, which is associated with microstructural changes of grain shape, orientation and hardness value does not exceed the proportional plastic area.
This study investigated the properties of mesocarbon anodes in the half-cell of sodium-ion batteries. The behavior of mesocarbon was examined using electrochemical methods. Cyclic voltammetry (CV) was applied with various scan rates to reveal the anodic-cathodic voltage and peak current. The CV profile allowed for predicting the energy storage mechanism of sodium ions in mesocarbon. The CV measurement of the half-cell Na | mesocarbon demonstrated the intercalation and de-intercalation of sodium ions in the graphene interlayer at 0.01 V and 0.12 V, respectively. Based on the Power law, the kinetics of sodium ion movement was controlled by the diffusion-dominant reaction. After 25 cycles, the electrochemical impedance spectroscopy (EIS) spectra exhibited increasing resistances in the solid-electrolyte interface (RSEI) and charge transfer (Rct), ranging from 53.8 to 65.6 Ω and 42.6 to 229 Ω, respectively. Considering the charge/discharge rate capability in the first five cycles, the mesocarbon could deliver a specific capacity of discharge of 42 mAh/g at 0.1 C and retain 73% of its capacity after 25 cycles.