1 August 2021 in Ceramics International
19 May 2022 in Nano Research
Solid-state batteries based on Li and nonflammable solid-state electrolytes (SSEs) have aroused the attention of numerous researchers because of their absolute safety and potentially high energy density. Most SSEs after coming into contact with Li are reduced, which leads to high interfacial charge-transfer impedance and dendrites formation. In this study, an “interlayer-Li pre-reduction strategy” was proposed to solve the above problem of reduction. An intermediate layer was introduced between solid electrolyte and Li, and it reacted with Li to produce a stable and ion-conductive interphase. Cubic garnet-type Nb-doped Li7La3Zr2O12 (Nb-LLZO) was selected as an example solid electrolyte since it is characterized by high ionic conductivity, feasible preparation under ambient conditions, as well as low cost. The high impedance arising from the reduction at the Nb-LLZO∣Li interface has limited its application. In this paper, a nano-scale Li phosphorus oxynitride (LiPON) layer was deposited on the Nb-LLZO pellets through radio frequency (RF) magnetron sputtering, which pre-reacted with Li in-situ to produce a lithiophilic, electronically insulating, and ionic conductive interphase. The produced interphase significantly inhibited the reduction of Nb5+ against Li and the formation and propagation of Li dendrites. It is noteworthy that Li∣LiPON∣Nb-LLZO∣LiPON∣Li cells stably cycled for over 2,000 h without any short circuit. This study emphasizes and demonstrates the significance of the pre-conversion of modification layer between unstable SSE and Li metal to improve interfacial stability.
24 May 2023 in Chemical Communications
Argyrodite-type LPSC sulfide solid electrolyte produced from a simple mixing plus mass sintering route at 480 °C delivers high ionic conductivity of over 20 mS cm−1 and good compatibility against a graphite anode and NCM622 cathode.
12 September 2024 in Journal of Materials Chemistry A
A non-crystalline strategy to improve Li + conductivity in Li 2 ZrCl 6 -family halide solid-state electrolytes for all-solid-state Li batteries.
18 March 2024 in Energy Materials
Solid-state batteries have garnered attention due to their potentiality for increasing energy density and enhanced safety. One of the most promising solid electrolytes is garnet-type Li7La3Zr2O12 (LLZO) ceramic electrolyte because of its high conductivity and ease of manufacture in ambient air. The complex gas-liquid-solid sintering mechanism makes it difficult to prepare LLZO with excellent performance and high consistency. In this study, an in-situ Li2O-atmosphere assisted solvent-free route is developed for producing the LLZO ceramics. First, the lithium-rich additive Li6Zr2O7 (LiZO) is applied to in-situ supply Li2O atmosphere at grain boundaries, where its decomposition products (Li2ZrO3) build the bridge between the grain boundaries. Second, comparisons were studied between the effects of dry and wet routes on the crystallinity, surface contamination, and particle size of calcined powders and sintered ceramics. Third, by analyzing the grain boundary composition and the evolution of ceramic microstructure, the impacts of dry and wet routes and lithium-rich additive LiZO on the ceramic sintering process were studied in detail to elucidate the sintering behavior and mechanism. Lastly, exemplary Nb-doped LLZO pellets with 2 wt% LiZO additives sintered at 1,300 °C × 1 min deliver Li+ conductivities of 8.39 × 10-4 S cm-1 at 25 °C, relative densities of 96.8%, and ultra-high consistency. It is believed that our route sheds light on preparing high-performance LLZO ceramics for solid-state batteries.
6 February 2025 in Rare Metals