21 December 2021 in IEEE Open Journal of Power Electronics
This paper presents the design and analysis of a high-density two-stage battery charger for mid-power applications like small electric vehicles and high-performance laptops utilizing gallium nitride (GaN) power devices. In addition to adherence of maximum junction temperatures, a thermal analysis is carried out for in-housing operation, which is particularly critical for fanless wall chargers. Design measures include calorimetric semiconductor selection, half-bridge miniaturization, thermally conductive epoxy resin and reference-based convection modeling for thermally optimized component placement using 3D-stacking. Furthermore, the remaining optimization potential of the charger is estimated by virtual prototyping. A 170 W hardware prototype is developed and tested, achieving a two-stage power section efficiency of 95.4 % with a maximum switching frequency of 550 kHz. This results in a power density in open-housing operation of 1.6 kW / dm. Using epoxy resin, copper and graphite heat spreaders, an in-housing operation power density of 1.1 kW / dm is achieved with minor reduction of output power due to surface temperature constraints.
17 April 2023 in IEEE Transactions on Power Electronics
Virtual prototyping, multiobjective optimization, and design automation are increasingly being used to meet the growing demands of modern power electronic applications in terms of efficiency and power density. These concepts are based on accurate loss models of the power semiconductors used. While for hard-switching, the double pulse test is an established electrical characterization method, soft-switching losses can only be determined by calorimetric measurements. Despite significant improvements in using transient approaches, calorimetric characterization of soft-switching loss energy is very time-intensive and requires complex measurement setups. This article presents a new automated calorimetric method with thermal impedance calibration that enables rapid and noninvasive switching loss measurements. Using ultrafast transient measurements and accelerated cooling phases in between, soft-switching loss maps can be determined based on hundreds of individual readings. The proposed measuring method is validated against hard-switching electrical double pulse test measurements. The method achieves a maximum error of $1.9 \,\%$ for the total loss measurement from $1-9 \,\mathrm{W}$ and an average measurement error of $16.5 \,\%$ for the soft-switching energy from $1-4 \,\mu \mathrm{J}$ of wide bandgap power semiconductors. In addition to comparing the results of different semiconductor technologies for use in a charger application, the manufacturers' simulation models are also analyzed with respect to soft-switching energy.
28 June 2023 in Applied Thermal Engineering