Aluminum-based composites containing either SiC (Al10%SiC) as the hard phase or a combination of SiC and MoS2 (Al10%SiC4%MoS2) have been synthesized following stir casting route. To overcome the poor wetting characteristics, magnesium was added in one of the composites (Al10%SiC4%MoS24%Mg) to improve the bonding between matrix and second phase. The results suggested an enhancement in hardness and strength of the composite containing SiC–MoS2 and Mg, thus indicating the effectiveness of Mg addition in improving the interfacial bonding strength. Tribological performance of the composites has been examined by carrying out pin-on-disk wear tests under dry sliding conditions at different normal loads of 9.8, 14.7, 19.6, and 24.5 N and at a constant sliding speed of 1 m/s. Both the friction coefficient and the wear rate have been found to reduce with addition of MoS2; however, bonding between the matrix and reinforcements was not good. Al10%SiC4%MoS24%Mg has shown the best tribological performance at all the loads in terms of the lowest friction coefficient and the lowest wear rate. The wear mechanism has been found to be a combination of adhesion and abrasion as indicated by the presence of some abrasive grooves and delaminated flakes at the worn surface and the X-ray examination of wear debris for all the materials used in the present investigation.
To explore the potential of directly grown multi-layer graphene as an agent in reducing friction and wear of steel on steel tribo-pair, multi-layer graphene films were synthesized on GCr15 steel in a low-pressure chemical vapor deposition (LPCVD) setup using a gaseous mixture of acetylene and hydrogen onto a bearing steel substrate. An interlayer of electroplated nickel was deposited on steel to assist and accelerate the graphene deposition. The tribological performance was evaluated using a ball-on-disc tribometer with an average Hertzian pressure of 0.2, 0.28, 0.34, and 0.42 GPa over a stroke length of 5 mm against GCr15 steel ball and compared with bare steel and nickel-plated steel. The results indicate that the friction coefficient is dependent on the applied load and decrease with increasing load, and the minimum friction coefficient of ∼0.13 was obtained for an applied normal load of 1 N; however, the coating failed after 250 cycles. The decrease in friction coefficient has been attributed to the homogenization of the deposited multi-layer graphene along the sliding direction and transfer of graphene to counter-face ball leading to inhibition of metal-metal contact. The investigation suggests that this kind of coating has the potential of improving the tribological performance of metal-metal tribo-pairs.
1 January 1996 in Bioscience, Biotechnology, and Biochemistry
Substituted 4,4,4-trifluoro-3-(indole-3-)butyric acids (TFIBAs), novel fluorinated plant growth regulators, were easily synthesized from substituted 2,2,2-trifluoro-l-(indole-3-)ethanols. The synthetic substituted TFIBAs showed marked root growth-promoting activity toward Chinese cabbage, lettuce, and rice plants. 5-MeO-2-Me-TFIBA (2d) had especially strong promoting activity toward Chinese cabbage, while 5-Me- TFIBA (2b) markedly promoted the root growth of all three plants. The promoting activity of TFIBAs halogenated at the 5-position in the indole nucleus of the molecule (5-Br- and 5-C1-TFIBA (2e and 2g)) was also greater than the activity of TFIBA, the original non-substituted compound. 5-N02-TFIBA (2h) with a strong electron-withdrawing group showed only very weak root growth-promoting activity.
17 October 2023 in Journal of Biomedical Materials Research Part B: Applied Biomaterials