At the beginning of 2016 the first direct detection of a gravitational wave by a laser-based Michelson interferometer has been reported. So far, the number of confirmed detections has raised to three and will certainly increase further. Thereby, mankind has an amazing new tool to observe and study the universe, namely by gravitational wave astronomy. However, in order to develop their full potential a more sensitive generation of earth-bound gravitational wave detectors will be required in the future. Current detectors are operating with solid-state laser systems at 1064nm but higher output power levels and longer wavelengths will be required by next-generation detectors. The requirements with respect to the laser sources, e.g. on the beam quality and the linewidth, are very challenging and unique. In recent years, it has been demonstrated that single-frequency fiber amplifiers are a very attractive concept as next-generation gravitational wave detectors laser sources. This paper reviews, highlights, and summarizes the corresponding research results, in particular regarding power scaling, noise properties, and coherent beam combination.
A current limit in power scaling of Yb-doped fiber amplifiers is the sudden onset of mode instabilities. We investigated this effect on a single-frequency Yb-doped photonic crystal fiber amplifier with a low mode instability threshold power. By measuring the overlap of the fiber output beam with the fundamental mode of an external cavity to be about 95%, we could exclude significant modal power transfer below a sharp power threshold. Furthermore, we directly measured the frequency resolved intensity noise spectra. No fluctuations in the overall output power were observed, but for the modal content different oscillation regimes were identified.
Gravitational wave detectors require linearly polarized single-frequency laser sources with a high fractional TEM00 mode content. We investigated the modal decomposition of a polarization maintaining photonic crystal fiber with a mode field diameter of 29 µm, operating in a single-frequency master-oscillator power-amplifier scheme, with respect to the TEMnm modes. Low degradation of the beam quality with increasing pump power could be observed, while a maximum power in the TEM00 mode of 203 W was achieved.
We experimentally investigated the influence of amplified spontaneous emission within the Brillouin gain bandwidth on the Brillouin scattering of a single-frequency signal. The experiments were performed for the case of artificial ASE injected in backward direction into a passive fiber, as well as in forward direction of a low-power fiber amplifier. A significant influence could be observed, when the ASE was counter-propagating to the signal. Injecting 160.6 nW of ASE within the Brillouin gain bandwidth led to a decrease of about 3 dB of the SBS-threshold of an approximately 335 m long passive fiber from about 80 mW to less than 40 mW. At a fixed signal power of 81 mW the backscattered power and the power in the Brillouin scattered Stokes maximum increased by a factor of 19.