2 October 2020 in Science
Competitive cooling with capacitors: Current large-scale cooling devices use vapor compression refrigeration. The efficiency of air conditioners has been optimized, but they can be noisy and rely on problematic greenhouse gases. Two groups now present designs for electrocaloric cooling using lead scandium tantalate capacitors that change temperature under an electric field. Y. Wang et al. obtained a very large heat flux using only solid materials and a cooling fan to remove heat from their device. Torello et al. used fluids for heat transfer, leading to a very large temperature difference between the hot side and the cold side. The new designs demonstrate the potential for devices that might be competitive with vapor compression–based appliances with further optimization. Science , this issue p. 129 , p. 125
12 September 2022 in Nature
Coming up with sustainable sources of electricity is one of the grand challenges of this century. The research field of materials for energy harvesting stems from this motivation, including thermoelectrics1, photovoltaics2 and thermophotovoltaics3. Pyroelectric materials, converting temperature periodic variations in electricity, have been considered as sensors4 and energy harvesters5–7, although we lack materials and devices able to harvest in the joule range. Here we develop a macroscopic thermal energy harvester made of 42 g of lead scandium tantalate in the form of multilayer capacitors that produces 11.2 J of electricity per thermodynamic cycle. Each pyroelectric module can generate up to 4.43 J cm−3 of electric energy density per cycle. We also show that two of these modules weighing 0.3 g are sufficient to sustainably supply an autonomous energy harvester embedding microcontrollers and temperature sensors. Finally, we show that for a 10 K temperature span these multilayer capacitors can reach 40% of Carnot efficiency. These performances stem from (1) a ferroelectric phase transition enabling large efficiency, (2) low leakage current preventing losses and (3) high breakdown voltage. These macroscopic, scalable and highly efficient pyroelectric energy harvesters enable the reconsideration of the production of electricity from heat.
2 June 2021 in Nature Communications
Electrocaloric materials are promising working bodies for caloric-based technologies, suggested as an efficient alternative to the vapor compression systems. However, their materials efficiency defined as the ratio of the exchangeable electrocaloric heat to the work needed to trigger this heat remains unknown. Here, we show by direct measurements of heat and electrical work that a highly ordered bulk lead scandium tantalate can exchange more than a hundred times more electrocaloric heat than the work needed to trigger it. Besides, our material exhibits a maximum adiabatic temperature change of 3.7 K at an electric field of 40 kV cm−1. These features are strong assets in favor of electrocaloric materials for future cooling devices.
17 June 2022 in Scripta Materialia
11 August 2025 in APL Electronic Devices
The demand for flexible, low-cost, and lightweight sensors is increasing, particularly for structural health monitoring in harsh environments exposed to temperature fluctuations and mechanical strain. Inkjet printing, an additive manufacturing technique for electronics, offers low-cost fabrication with high spatial resolution. In this work, we present strain sensors fabricated by inkjet-printing silver onto flexible Kapton substrates. The sensing grid is protected from the environment by a polymeric encapsulant. The sensors exhibit a linear increase in resistance with increasing strain, with gauge factor values ranging from 1.40 to 1.80 recorded over a temperature range of −40 to 100 °C. Furthermore, we demonstrate the applicability of these sensors for monitoring the mechanical deformation of a propellant tank with an aluminum liner. The strain sensor was printed directly onto the Kapton, which was pre-glued on a curved surface (tank). To compensate for temperature effects, two strain gauges, i.e., one aligned in the hoop direction and the other in the axial direction, were connected in a half-Wheatstone bridge configuration. A linear increase in output voltage with rising internal pressure up to 50 bar was observed, confirming the potential of inkjet-printed sensors for direct integration into structural health monitoring systems.