Lalit Singh

Lalit Singh

Auto-generated profile, based on publicly available information

Lalit Singh

School of Electrical and Electronic Engineering, Nanyang Technological University, Singapore, Singapore

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
9 August 2019 in Optics Letters
Verified
Journal Article
Closed access
LSLalit Singh
Lalit Singh
SJSourabh Jain
Sourabh Jain
MKMukesh Kumar
Mukesh Kumar
An electrically writable resistive memory with optical readout based on silicon nanophotonic structure is proposed. Hybridization of optical and surface plasmonic modes in the device enables nanoscale optical confinement to efficiently detect the resistive memory effect in a 13 nm thick SiO2 layer sandwiched between p-type silicon and gold. Electrical write and optical readout capabilities of the proposed device are experimentally demonstrated with well-defined optical and electrical hysteresis curves at a wavelength of 1550 nm. The p-type silicon carries multifold benefits-it provides low propagation loss and a defect-free interface resulting from thermally (locally) grown oxide; the combination of p-silicon, SiO2, and gold results in a self-rectifying operation to enable the realization of a memory stack. An on-off extinction ratio of 10 dB is demonstrated for a 5 mm long device. The proposed device shows an inherent stochastic property where the set (writing) voltage reduces in each set-reset cycle, which can be used for optical readout of synaptic weight for neuromorphic computations.

11 April 2019 in IEEE Sensors Journal
Verified
Journal Article
Closed access
SSSulabh Srivastava
Sulabh Srivastava
LSLalit Singh
Lalit Singh
SJSourabh Jain
Sourabh Jain
MKMukesh Kumar
Mukesh Kumar
A nanophotonic sensing platform based on slot-waveguide is proposed. We numerically investigate the effect of the structural parameters on the sensing properties. In simulation, the slot is created between the cladding made up of silicon and TiO 2 grating. The presence of TiO 2 overlay provides the two-fold benefit of bio-compatibility with higher sensitivity. A gold layer under top SiO 2 is used to enhance optical confinement in the slot region. The surface properties of thin layers of APTMS, sol-gel prepared TiO 2 , and gold are experimentally analyzed. The proposed device shows full width at half maximum of 4 nm which is narrow enough to detect small changes in the refractive index of the surrounding region. The device is numerically shown to detect surface antigen HBsAg, a principal marker of hepatitis-B viral infection, with a high sensitivity of 1200 nm/RIU with a figure of merit of 300. The device offers flexibility in accommodating the bio-sample in a desirable area. An analysis on the fabrication tolerance of the device is also given.

30 November 2021 in Nanophotonics
Verified
Journal Article
Open access
PDF file
VKVishal Kaushik
Vishal Kaushik
SRSwati Rajput
Swati Rajput
SSSulabh Srivastav
Sulabh Srivastav
LSLalit Singh
Lalit Singh
PBPrem Babu
Prem Babu
MKMukesh Kumar
Mukesh Kumar
Miniaturized, low‐cost wavelength detectors are gaining enormous interest as we step into the new age of photonics. Incompatibility with integrated circuits or complex fabrication requirement in most of the conventionally used filters necessitates the development of a simple, on‐chip platform for easy‐to‐use wavelength detection system. Also, intensity fluctuations hinder precise, noise free detection of spectral information. Here we propose a novel approach of utilizing wavelength sensitive photocurrent across semiconductor heterojunctions to experimentally validate broadband wavelength detection on an on‐chip platform with simple fabrication process. The proposed device utilizes linear frequency response of internal photoemission via 2‐D electron gas in a ZnO based heterojunction along with a reference junction for coherent common mode rejection. We report sensitivity of 0.96 μA/nm for a broad wavelength‐range of 280 nm from 660 to 940 nm. Simple fabrication process, efficient intensity noise cancelation along with heat resistance and radiation hardness of ZnO makes the proposed platform simple, low‐cost and efficient alternative for several applications such as optical spectrometers, sensing, and Internet of Things (IOTs).

24 June 2021 in Journal of Lightwave Technology
Verified
Journal Article
Closed access
LSLalit Singh
Lalit Singh
SSSulabh Srivastava
Sulabh Srivastava
VKVishal Kaushik
Vishal Kaushik
SRSwati Rajput
Swati Rajput
RMRahul Dev Mishra
Rahul Dev Mishra
MKMukesh Kumar
Mukesh Kumar
An optically assisted electrically writable non-volatile nanophotonic resistive switch based on silicon is proposed with an optical readout capability. The proposed scheme also address the issue of undesired current overshoot in resistive switches. Optical assistance is provided with the blue pump light which leads to the photogenrated charge carriers in the active $TiO_{2}$ layer to lower the set voltage and to improve the endurance of the device. A large hysteresis of the current loop in presence of a blue wavelength of light at lower voltages is observed with the proposed three-layered device of Ag/ $TiO_{2}$ /p-Si. The electrical resistive state of the device is readout at 1550-nm of wavelength with an optical extinction ratio of 16 dB for 1 mm long device. The optical guidance with the formation (low resistance state) and dissolution (high resistance state) of conductive path filament in the active layer of $TiO_{2}$ is also discussed. The proposed nanophotonic functionality can be useful in realizing ultra-compact on-chip devices for optical switching, modulation and neuromorphic computing.

18 December 2019 in IEEE Sensors Journal
Verified
Journal Article
Closed access
SJSourabh Jain
Sourabh Jain
SSSulabh Srivastava
Sulabh Srivastava
SRSwati Rajput
Swati Rajput
LSLalit Singh
Lalit Singh
PTPragya Tiwari
Pragya Tiwari
SUSulabh
Sulabh
A silicon-based compact comb-like asymmetric grating is proposed as a thermally stable optical filter for label-free sensing applications. The device is designed and fabricated with a cavity section introduced between the two grating regions which are partially etched in the lateral direction to ensure the nonzero coupling of the fundamental and first-order modes in the propagation and counter-propagation direction. To demonstrate refractive index sensing, resonance shift in the device is measured with sodium chloride (NaCl) dissolved in DI water. In contrast to conventional Bragg grating where stopband lies in the transmission spectrum, the proposed device allows a single narrow passband transmission peak with a large Free Spectral Range (FSR) attributed to the engineered photonic bandgap of two modes present in the waveguide region. The device is deliberately designed such that slightly wide resonance peak is obtained that makes device operation thermally stable for a large temperature variation of ±15 K. A higher-order leaky mode with strong light-analyte interaction (due to long corrugation width) in the gratings governs high sensitivity of ≈ 352 nm/RIU for different concentrations of NaCl from 0% to 10% in the Deionized (DI) water with a small footprint area of 18 μm2 only. Proposed filter characteristics are well suited for multifunctional applications in integrated photonic devices.

10 September 2020 in IEEE Sensors Journal
Verified
Journal Article
Closed access
SSSulabh Srivastava
Sulabh Srivastava
LSLalit Singh
Lalit Singh
SJSourabh Jain
Sourabh Jain
MKMukesh Kumar
Mukesh Kumar
A nanophotonic biosensing platform based on an engineered slot waveguide is proposed. The proposed device based on Fano resonance which consists of a periodic arrangement of two rows of nano-disks and rectangular grating. The periodically arranged nano-disk structure in the form of engineered slot waveguide provides enhanced light-matter interaction and easy accommodation of bio-samples. The surface morphology of (3-Aminopropyl) trimethoxysilane (APTMS) as a functionalized layer on the silicon surface is experimentally analyzed. The proposed sensor device can detect very small refractive index change of 0.0008. Based on refractive index sensing, the device numerically exhibits a high sensitivity of 1463 nm/RIU for some viral infections including hepatitis B the with a Figure of Merit (FOM) of 471 for refractive index change of 0.02. The limit of detection for the proposed device is 1.02 x10⁻³ RIU (Refractive Index Unit). The proposed scheme with Fano like resonance spectrum carries a great potential for on-chip and off-chip nanoscale optical devices and sensors.