5 November 2020 in Journal of Applied Physics
The surface Cs–O activation process directly determines quantum efficiency and stability of negative-electron-affinity photocathodes. To investigate the effects of excessive Cs and O supply on activation and to explore a more effective Cs–O activation recipe, Cs–O activation experiments of GaAs(100) photocathodes are carried out based on the current-driven solid Cs and O dispensers. By a comparison of differences in activation photocurrent, quantum efficiency, and photocurrent decay, it is found that the recipe of excessive O and non-excessive Cs is not suitable for activating GaAs photocathodes, while the recipe of continuous and completely excessive Cs along with intermittent and non-excessive O can achieve the most excellent photoemission performance, including the highest quantum efficiency in the long-wave threshold region and best stability under intense light irradiation after activation. Furthermore, this improved activation recipe with the least Cs–O alternating cycles is easier to operate. Combined with density functional calculations and dipole layer model, it is found that the activation recipe of completely excessive Cs and non-excessive O can form effective dipoles to the greatest extent, and avoid the direct interaction between As atoms and O atoms to form As–O–Ga oxides on the GaAs(100) reconstructed surface.
10 December 2022 in Modern Physics Letters B
15 May 2025 in Surfaces and Interfaces
19 August 2024 in SSRN Electronic Journal
Negative-electron-affinity AlGaAs photocathodes offer applications in underwater detection and green-laser driven electron sources due to their adjustable response threshold, long operating lifetime and fast response time. However, the difficulty of removing surface Al oxide is a key factor limiting the improvement of photoemission performance of AlGaAs photocathodes. To prevent oxidation of AlGaAs from exposure to air, a thin GaAs cap layer is commonly employed as the protective layer. Removing the GaAs cap layer and obtaining a clean and smooth AlGaAs surface are prerequisites for achieving high photoemission performance. Three sets of two-step chemical etching experiments were designed to remove the GaAs cap layer and obtain an AlGaAs emission surface favorable for Cs-O activation. By surface elemental analysis and surface topography test, it was found that the sample treated by the two-step chemical etching with the C6H8O7: H2O2 mixed solution and diluted HCl solution exhibited the lowest surface oxidation degree and roughness, and possessed the highest quantum efficiency over the entire waveband after activation. In additional, by fitting the experimental quantum efficiency curves, it is confirmed that the lower surface oxidation degree and roughness can effectively optimize surface barrier and enhance the photoelectron escape probability, resulting in the higher quantum efficiency.