16 May 2019 in IEEE Transactions on Industrial Electronics
This paper introduces a novel single-phase buck-boost (non-)inverting variable-frequency AC-AC converter that offers a higher efficiency compared to the competitors. This converter utilizes a lower number of semiconductors. A simple and flexible switching strategy is also proposed, which generates the desired output waveform avoiding unnecessary high-frequency switching operation of semiconductor devices. A high reliable operation due to the elimination of the input source shoot-through risk, an inherent commutation capability that mitigates the voltage spikes across the semiconductors, a lower semiconductors rating requirement, an improved input current waveform quality and a smaller required input filter inductor are the main advantages of the proposed converter. Thus, the proposed converter can be successfully applied to many industrial applications such as medium-frequency transformer-isolation (MFT) for traction and wind turbine converters, AC-DC high-voltage conversion based on Cockcroft-Walton circuit and induction heating systems. The theoretical achievements and claims are all confirmed through extensive experimental tests on a 200-W laboratory setup.
5 December 2019 in IEEE Transactions on Industrial Electronics
5 February 2020 in IEEE Transactions on Industrial Electronics
A simple and efficient single-phase direct AC to AC converter with the possibility to be utilized as a voltage buck or buck-boost converter is proposed in this paper. The proposed converter offers higher efficiency than the competitors with a lower number of semiconductors. The proposed switching strategy minimizes the high frequency operation and simultaneous conduction of semiconductors during each mode of operation. Besides a higher efficiency, the other major advantages of the proposed converter can be mentioned as eliminating the risk of input source shoot-through, a lower number and total rating of semiconductors, defined by switching device power (SDP) parameter, a lower number and smaller size of reactive components, a better input current quality and lower filtering requirements. The theoretical claims are confirmed through experiments on a 480W prototype built in laboratory.
26 September 2018 in IEEE Transactions on Industrial Electronics
This paper proposes two coupled-inductorsbased Z-source networks, called the modified series and tapped switched-coupled-inductors quasi-Z-source networks (mSSCL-qZSN and mTSCL-qZSN). These networks offer high voltage gains with less-than-unity winding turn ratios ( $n<1$ ) resulting in reduced inductive element size. Other achievements can be mentioned as less number and rating of active components and higher efficiency. In addition, a lower magnetic core size is required for the proposed Z-source networks due to the lower peak magnetizing current. The performance principles and detailed comparative analysis are provided and confirmed through experiments on a 200W DC-DC converter.
16 February 2018 in IEEE Transactions on Power Electronics
In this paper, a novel direct ac-ac converter based on the coupled inductor Z-source networks is proposed that offers a wide range of buck-boost operation. A total of two Z-source networks, called the coupled switched inductor and the modified switched coupled inductor, are employed that enable the ac-ac converter to deliver a wide voltage range. The proposed converter with both networks provides free-wheeling current paths for the inductors currents during the state transitions, which results in solving the commutation problems and the need for snubber circuits. A simple switching strategy is then proposed that helps to share a common magnetic core between the coupled inductors. For any particular voltage gain, the proposed structures require a smaller duty cycle compared to the conventional ones; therefore, a smaller inductance is required. Simulation and experimental results are provided to confirm the theoretical achievements.
5 April 2018 in IEEE Transactions on Industrial Electronics
A new class of impedance networks is proposed in this paper. The proposed coupled-inductors-based impedance cells, called the series and the tapped switched-coupled-inductors, are employed within the (quasi) switched boost networks. The achieved impedance networks based on the proposed cells offer very high conversion gains with less-than-unity turn ratios (n <; 1), which simplifies the realization of the magnetic element and at the same time reduces the number and size of passive components. The high boosting capability is achieved with small shoot-through durations that bring some additional advantages, such as low ratings of switching devices. The circuit analysis and operation concepts as well as a design procedure for the components of the proposed impedance networks are presented. Theoretical achievements are confirmed through experiments on a 220 W dc-dc converter laboratory setup.