Jan Loof

Jan Loof

Auto-generated profile, based on publicly available information

Jan Loof

Department of Mechanical Engineering, Eindhoven University of Technology, Eindhoven, The Netherlands

Research Focus & Metrics

Academic Career Length

9Years (2018-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 March 2018 in Vehicle System Dynamics
Verified
Journal Article
Open access
JLJan Loof
Jan Loof
IBIgo Besselink
Igo Besselink
HNHenk Nijmeijer
Henk Nijmeijer
This paper describes the coupling between a three degrees of freedom steering-system model and a multi-body truck model. The steering-system model includes the king-pin geometry to provide the correct feedback torque from the road to the steering-system. The steering-system model is combined with a validated tractor semi-trailer model. An instrumented tractor semi-trailer has been tested on a proving ground and the steering-wheel torque, pitman-arm angle, king-pin angles and drag-link force have been measured during steady-state cornering, a step steer input and a sinusoidal steering input. It is shown that the steering-system model is able to accurately predict the steering-wheel torque for all tests and the vehicle model is accurate for vehicle motions up to a frequency where the lateral acceleration gain is minimum. Even though the vehicle response is not accurate above this frequency, the steering-wheel torque is still represented accurately.

28 August 2019 in IEEE Transactions on Intelligent Vehicles
Verified
Journal Article
Closed access
JLJan Loof
Jan Loof
IBIgo Besselink
Igo Besselink
Henk NijmeijerHenk Nijmeijer
Henk Nijmeijer
To bridge the gap between autonomous and normal steering during low lateral acceleration maneuvers, a steering-wheel torque controller is developed. It consists of three controllers in series, a high-gain feedback steering-wheel torque controller, a nonlinear steering-angle controller, and a linear yaw-rate controller. A validated two degrees of freedom steering-system model, in combination with a single-track vehicle model, is used to determine the controller parameters. Driving tests with different drivers have been executed to find a comfortable steering-wheel torque/angle relation. This relation is maintained throughout the lane change by specifying the steering-wheel torque as a function of the steering-wheel angle tracking error. Experiments show promising results regarding the driver/vehicle interaction, but also show that a system to detect the lanes and the vehicle position on the road is required for further improvement.