17 January 2018 in IEEE Transactions on Industrial Electronics
In microgrids, distributed load sharing plays an important role in maintaining the supply-demand balance of power. Because False Data Injection (FDI) is one of the crucial threats faced by future microgrids, the study of the impact of FDI on distributed load sharing is of both theoretical merit and practical value. In this paper, we consider the distributed load sharing problem of the microgrids operating in autonomous mode under FDI. Each bus is assumed to be equipped with an agent. Under a well developed distributed load sharing protocol based on multiagent systems, we first construct an FDI attack model, where the attacker is capable of injecting false data into the bus agents. Then, a utilization level is introduced for coordinating generators and its variation is evaluated in the presence of FDI attacks with given injection strategies. The stable region of the microgrid is defined and conditions are given to determine stability. Finally, the theoretical results are validated on the Canadian urban distribution system.
5 December 2018 in IEEE Transactions on Industrial Informatics
6 July 2016 in IEEE Transactions on Smart Grid
This paper presents a fully distributed power sharing control strategy for a microgrid with integration of multiple inverter-based intermittent distributed generators (IDGs) using a need-based aperiodic data transmission scheme. The control objective is to maintain the supply-demand balance of active power. According to the proposed control strategy, each bus in a microgrid has an associated bus agent. First, it is shown that by controlling the utilization levels of IDGs to a common value, which can be calculated using the total available power and total demands, the supply-demand balance can be maintained. Subsequently, we propose a multiagent system (MAS)-based discovery algorithm to discover the global microgrid information. Compared with most existing MAS-based load sharing studies, the proposed algorithm is capable of reducing data communication requirements since the agent only broadcasts its state to its neighbors when an event occurs. Furthermore, the distances between neighbor agents have been considered in the threshold of event condition to improve its efficiency in reducing data communication. Finally, the effectiveness of the proposed scheme is validated on the Canadian urban distribution system.
18 June 2019 in IEEE Transactions on Smart Grid
This paper is initiated by considering an emerging practical issue that dc microgrids should be able to operate with a large-signal stability sense when feeding both resistive loads and constant power loads (CPLs). To be more specific, the stability should be ensured in the presence of large variations of integrated renewable sources and CPLs, system internal uncertainties, external disturbances, coupled interactions, and other adverse effects. From a control point of view, we intentionally propose a general solution to realize the exact decentralized tracking control task for interconnected systems. First, an alternative finite-time feedforward decoupling mechanism is presented, which is essentially different from existing design approaches via feedback domination or recursive cancellation processes. Second, a composite controller can be straightforwardly built from the system information since it is detached from stability analysis. One major advantage of the proposed design framework is that it reduces the design complexity and therefore facilitates the practical implementations. As a direct application, a simple decentralized composite controller is constructed for an autonomous dc microgrid system. Both numerical simulation and experimental comparison results show that a large-signal stability is achieved for dc microgrids under a range of different situations.
31 January 2022 in IEEE Transactions on Smart Grid
Distribution grid topology information is the basis of grid analysis functions such as power flow and state estimation. Due to lack of monitoring and measurement devices in low-voltage distribution grids (LVDGs), the intermediate nodes connecting LVDG transformers to end-users cannot upload the nodal operation status. The existence of these latent nodes poses a huge challenge to LVDG topology identification. This paper proposes a LVDG latent node and topology identification method based on end-user data from smart meters. Specifically, a special latent-node embedded Bayesian network, defined as latent tree model, is proposed to provide probabilistic representation for all possible LVDG topologies. A search-based algorithm is proposed to generate candidate topologies and then a Bayesian information criterion is proposed to describe the accuracy of the candidate topologies. Meanwhile, the Expectation-Maximization algorithm is introduced to complement measurement lacking latent nodes. Test results in different simulation scenarios and practical LVDGs demonstrate the effectiveness and robustness of the proposed method.
29 May 2023 in IEEE Transactions on Industrial Informatics
The topology identification of the distribution system is the foundation of state estimation and system analyses. However, the lack of sufficient measurement devices in practice makes full-scale identification of distributed grids hardly achievable. On the other hand, the high-scale distributed renewable energy grid-connected aggravates the complex associations between nodal injection power and voltage. Taking full advantage of it, this article proposes a novel data-driven approach to identify the topology by backtracking the Jacobian matrix from the voltage and power data from grid terminal units. Specifically, a data-driven power-to-voltage mapping model is proposed. It uses the adaptive online deep learning algorithm based on hedge backpropagation to model the mapping relationship of terminal active power, reactive power, and voltage. Then, backtracking the mapping model, a Jacobian matrix consisting of the partial derivative of voltage to the active and reactive power is obtained, which reflects the connectivity between nodes. Finally, through the Jacobian matrix, a maximum connectivity screening algorithm is developed to generate the topology of medium distribution systems. The effectiveness of the proposed method is verified on IEEE 33-node, IEEE 123-node, and actual distribution systems.