Eric Austin

Eric Austin

Auto-generated profile, based on publicly available information

Eric Austin

University of Texas at San Antonio

Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2026 in The Planetary Science Journal
Verified
Journal Article
Open access
AHAdis Husić
Adis Husić
XIXinting馨婷Yu余
Xinting馨婷Yu余
RBRyan C. Blase
Ryan C. Blase
EPEdward L. Patrick
Edward L. Patrick
EAEric Austin
Eric Austin
AWAlan G. Whittington
Alan G. Whittington
The Cassini–Huygens mission detected large negative ions in Titan’s ionosphere at pressures as low as 10 −6 Torr. These ions ultimately polymerize to form Titan’s complex organic haze particles, which are observed throughout the atmosphere and potentially on the surface. Laboratory analogs of these hazes, known as tholins , have been used to study Titan’s aerosols; however, most are produced at much higher pressures. The influence of formation pressures on key physical properties—such as particle size, density, surface energy, and mechanical strength—remains poorly constrained. These properties govern the haze’s aggregation efficiency, radiative behavior, and surface–atmosphere interactions, shaping Titan’s climate and surface. To investigate the effects of formation pressure, we generate tholins using a newly developed cold plasma discharge system. A 95% nitrogen and 5% methane gas mixture is exposed to plasma at two pressures, 1 Torr and 0.125 Torr. For both samples, we measure the production rate, particle size, morphology, density, surface free energy, Young’s modulus, and nanoindentation hardness. While particle size, morphology, surface energy, and Young’s modulus are similar across both pressures, tholins produced at lower pressure exhibited a threefold lower production rate, but a higher density and nanoindentation hardness. These variations likely reflect pressure-dependent changes in chemical structure, porosity, and mechanical strength. Because Titan’s hazes form at much lower pressures than investigated here, actual haze particles are potentially even denser and mechanically stronger than our analogs, with implications for aerosol aggregation, aeolian and fluvial transport, and surface modification on Titan.

9 July 2025
Verified
Conference Paper
Open access
EAEric Austin
Eric Austin
XYXinting Yu
Xinting Yu
AHAdis Husić
Adis Husić
DFDionysis Foustoukos
Dionysis Foustoukos
KMKelly Miller
Kelly Miller
NTNgoc Truong
Ngoc Truong
Introduction: Organic molecules are ubiquitous as primitive Solar System building blocks and are also central to astrobiology, yet their origins and evolution remain debated. These organics likely play crucial, yet poorly constrained, roles in fundamental planetary processes during the formation and evolution of planetary systems. Models of planet formation struggle to explain the rapid aggregation of dust into planetesimals, facing collisional barriers where silicate grains tend to fragment rather than stick [Birnstiel (2024)]. The presence of organic matter in chondrites and comets has fostered the hypothesis that organic matter may coat these grains, enhancing their sticking efficiency [Homma et al. (2019)]. However, current attempts to quantify this effect remain theoretical, relying on values for analogs such as terrestrial coal to represent parameters for organics present within the interstellar medium (ISM) or protosolar nebula (PSN) [Homma et al. (2019)]. Meanwhile, understanding the thermal evolution and potential habitability of icy moons and dwarf planets hinges on modeling their internal structure and heat sources, primarily tidal dissipation [Bagheri et al. (2022)]. Observations suggest that these bodies contain significant amounts of low-density refractory material, likely primitive organic matter, mixed with rock and ice [Reynard and Sotin (2023)]. The amount and the mechanical/viscoelastic properties of this organic fraction would critically influence tidal heating efficiency and internal dynamics. Accurately modeling planetesimal aggregation and icy world evolution thus requires direct measurements of the physical properties of relevant Solar System organics. Insoluble Organic Matter (IOM), the dominant organic component in chondrites, represents a key material whose origin (interstellar, nebular, parent-body) is complex [Alexander et al. (2017)]. This study utilizes nanoindentation and helium pycnometry to characterize two fundamental physical properties (Young's modulus, Y​; grain density, 𝜌) of chondritic IOM (CIOM) and synthetic analogs, aiming to provide crucial data for planet formation and icy body models while simultaneously shedding new light on the complex origins and processing history of IOM. Methods: We measured Young's modulus using dynamic nanoindentation [Oliver and Pharr (2004)] (KLA iMicro) on CIOM extracted from three carbonaceous chondrites (CCs): Murchison (CM2), Tarda (C2), and Grosvenor Mountains (GRO) 95577 (CR1) [Cody et al. (2002)]. These represent materials with varying degrees of parent body aqueous alteration. Using nanoindentation and helium pycnometry (Anton Paar Ultrapyc 3000), we also measured the Young's modulus and density of synthetic IOM (SIOM) synthesized hydrothermally via dextrose carbonization [Foustoukos et al. (2021)]. Young’s modulus measurements were compared to synthetic organic analogs representing key formation/processing pathways: (1) Ice irradiation residues [Piani et al. (2017)]; (2) Aqueous alteration organics (SIOM); and (3) Gas irradiation organics (Titan tholin analogs, [Yu et al. (2018)]). Density measurements were compared to terrestrial organic analogs typically used in planetary modelling. CIOM (and SIOM following density measurements) samples were embedded in epoxy, polished (Pace Technologies NANO-2000S), and indented under N2. Y​ was determined by the instrument’s software from load-displacement curves, averaging data from depths > 500 nm. Results: Significant differences in mechanical stiffness were observed (Figure 1a). Synthetic analogs showed distinct moduli linked to formation pathways: stiffness increased in the order Ice Irradiation Residues < Aqueous Alteration Organics < Gas Irradiation Organics. CIOM from Murchison, Tarda, and GRO 95577 exhibited intermediate stiffness (Y ~ 2-6 GPa), about an order of magnitude stiffer than ice irradiation residues (Y ~ 0.1 GPa). Their moduli fell between those of aqueous alteration analogs (SIOM measured at 0.69 ± 0.4 GPa) and gas irradiation analogs (~ 10 GPa). Notably, CIOM from GRO 95577, the most primitive sample [Alexander et al. (2010)], was mechanically softer than Murchison and Tarda IOM, suggesting that the aqueous alteration of the parent body may stiffen the structure of IOM. Moreover, measurements for both CIOM and SIOM indicate the material is more flexible (lower Y) than water ice (~ 10 GPa) and silicates (> 50 GPa). Density measurements of SIOM (Figure 1b) align with values for terrestrial coal and kerogen currently used in planetary modeling.Discussion: The intermediate stiffness of CIOM, significantly different from highly flexible ice residues but generally softer than stiff gas irradiation products, points towards a complex, multi-stage history. Based on our data, we favor a model involving the formation of precursors, likely in cold environments (consistent with isotopes), followed by subsequent processing (e.g., aqueous alteration, gas-phase reactions/irradiation), gradually creating stiffer macromolecules. Further experimentation investigating the effects of aqueously altering ice and gas irradiation organics, as well as measuring the Young’s modulus of other CC petrological types aside from those analyzed thus far (CM2, C2-ung, CR1), is necessary to confidently substantiate whether aqueous alteration affects the stiffnes of the material.Our Young’s modulus measurements confirm that IOM is significantly more flexible than silicates. This increased elasticity, along with the density measurements, results in an enhanced sticking efficiency during dust collisions, likely promoting aggregation and assisting in overcoming fragmentation barriers, thereby potentially accelerating planetesimal growth compared to silicate-only models.Our finding that IOM has a significantly lower Young's modulus than rock implies higher shear compliance. Therefore, an organic-rich component within an icy...

1 October 2026 in The Planetary Science Journal
Verified
Journal Article
Open access
EAEric C. Austin
Eric C. Austin
XIXinting馨婷Yu余
Xinting馨婷Yu余
CHChao He
Chao He
CPCara Pesciotta
Cara Pesciotta
ESElla Sciamma-O’BRien
Ella Sciamma-O’BRien
PMPatricia McGuiggan
Patricia McGuiggan
The organic haze particles on Titan play important roles in atmospheric cloud formation and aerosol–lake interactions. These processes are strongly influenced by the surface energy of the haze particles, which controls cohesion and wetting behavior. This study presents a comparative analysis of 32 laboratory-produced haze analog samples (“tholins”) synthesized across three laboratories. Using contact angle measurements, we determine the total surface energy and its dispersive and polar components for all samples, systematically evaluating the effects of substrate choice, air exposure, initial N 2 /CH 4 gas mixture, and experimental setup. We find that tholin samples exhibit minimal substrate dependence, whereas exposure to ambient air substantially modifies the surface chemistry, altering the balance between dispersive and polar components. Thus, future Titan-relevant surface property measurements may use any substrate but must keep samples pristine. Surface energies vary weakly across methane concentrations, from 1% to 10% CH 4 in N 2 , indicating that Titan’s hazes formed at different altitudes should exhibit broadly similar cohesiveness. In contrast, experimental conditions such as gas exposure time and energy source produce the dominant differences in surface energy, driven largely by variations in polar components. Despite these differences, tholin samples exhibit high dispersive components, implying that Titan’s hazes should act as efficient cloud condensation nuclei for hydrocarbon clouds and should generally sink into Titan’s lakes. Given observed ethane ice clouds, we conclude that cold plasma tholins may be better physical analogs for Titan’s hazes than samples produced with far-UV irradiation, though intrinsic surface energies of UV tholins remain uncertain due to film thickness limitations.