1 August 2018 in Nano Energy
28 April 2014 in Applied Physics Letters
Vibration-based energy harvesters with multi-layer piezoelectrets (ferroelectrets) are presented. Using a simple setup with nine layers and a seismic mass of 8 g, it is possible to generate a power up to 1.3 µW at 140 Hz with an input acceleration of 1g. With better coupling between seismic mass and piezoelectret, and thus reduced damping, the power output of a single-layer system is increased to 5 µW at 700 Hz. Simulations indicate that for such improved setups with 10-layer stacks, utilizing seismic masses of 80 g, power levels of 0.1 to 1 mW can be expected below 100 Hz.
4 May 2015 in Applied Physics Letters
Vibration-based electret energy harvesters with soft cellular spacer rings are presented. These harvesters are closely related to recently introduced electret accelerometers; however, their development targets are partially differing. Various harvesters with seismic masses from 8 to 23 g and surface potentials in the 500 V regime were built and characterized and powers of up to 8 μW at about 2 kHz and an acceleration of 1 g were measured. An analytical model is presented which, for instance, allows the calculation of the frequency response of the power output into a given load resistance. Finally, experimental and calculated results are compared.
9 May 2016 in Applied Physics Letters
Sandwiched fluoroethylene propylene films with charged, parallel-tunnel voids between the layers, which exhibit high d31 piezoelectric activity, were designed. Stripes of such piezoelectrets were exposed to mechanical stress in length direction by a seismic mass excited to vibrations. Due to the piezoelectricity of the films, a current in a terminating resistor is generated. The harvested power across the resistor amounts to about 0.2 mW for a seismic mass of 2 g and an acceleration of 1 g. In comparison with other piezoelectret or with poly(vinylidene fluoride) harvesters, the generated power referred to equal acceleration and force, is significantly larger.
4 June 2015 in IEEE Transactions on Dielectrics and Electrical Insulation
Vibration-based energy harvesting with single- or multiple-layer (stacked) piezoelectret films is discussed. First, a mechanical and an electrical model for this kind of energy harvesting is established and equations for the generated charge, current, voltage, and power are derived. In particular, the case where the electrical corner frequency equals the mechanical resonance frequency of the film stack combined with the seismic mass is of importance since harvesting at this frequency results in maximal generated power. Then, experimental results for harvesters with single layers and with stacks of piezoelectret films are presented. The data confirm the predicted dependence of the generated power on terminating resistance, frequency, seismic mass, acceleration, and number of film layers in the stack. If the stress on the piezoelectret layers, generated by the accelerated seismic mass, is larger than 3 kPa, a nonlinear increase of the generated power with stress is observed. The maximum power harvested with a single-layer piezoelectret is 18 μW for an acceleration of 9.81 m/s2 and for a seismic mass of 40 g. A three-layer harvester yields an increase of the maximum power close to a factor of √3.
11 July 2016 in Phase Transitions
Vibration-based energy harvesting with piezoelectrets can be significantly improved by using multiple layers of these materials. In particular, folding or stacking of piezoelectrets or a combination of these methods results in increased power output of the energy harvesters. The possibilities of these procedures are explored, together with the effect of seismic mass, resonance frequency, and terminating resistance. It is found that with seismic masses of about 20 g and using radiation-crosslinked polypropylene (IXPP) as a piezoelectret, power outputs of up to 80 µW can be achieved for an acceleration of 1 g. Expected dependencies of generated power on frequency, folding and stacking parameters, in particular number of layers, and on seismic mass, are confirmed.