9 October 2020 in Photonics Research
Indium gallium nitride (InGaN)-based light-emitting diodes (LEDs) are considered a promising candidate for red-green-blue (RGB) micro displays. Currently, the blue and green LEDs are efficient, while the red ones are inefficient for such applications. This paper reports our work of creating efficient InGaN-based orange and red LEDs on silicon(111) substrates at low current density. Based on the structure of InGaN yellow LEDs, by simply reducing the growth temperature of all the yellow quantum wells (QWs), we obtained 599 nm orange LEDs with peak wall-plug efficiency (WPE) of 18.1% at . An optimized QW structure was proposed that changed two of the nine yellow QWs to orange ones. Compared with the sample containing nine orange QWs, the sample with two orange QWs and seven yellow QWs showed similar emission spectra but a much higher peak WPE up to 24.0% at with a wavelength of 608 nm. The improvement of peak WPE can be attributed to the improved QW quality and the reduced active recombination volume. Subsequently, a series of efficient InGaN-based orange and red LEDs was demonstrated. With further development, the InGaN-based red LEDs are believed to be attainable and can be used in micro LED displays.
1 June 2020 in Journal of Luminescence
31 May 2019 in Journal of Applied Crystallography
1 December 2019 in Superlattices and Microstructures
11 May 2020 in Journal of Applied Physics
Five types of GaN-based yellow light-emitting diodes (LEDs) with both a V-pit and a hole blocking layer (HBL) have been investigated numerically. The simulation results show that the GaN hole blocking layer in the p region (HBLP) can not only increase the ratio of the hole current via the V-pit, but also increase the electron leakage into the p layer via the flat region, leading to the lower internal quantum efficiency (IQE). Compared to the GaN HBLP, the Al0.5Ga0.5N HBLP is helpful in suppressing the electron leakage via the flat region to the p layer; however, it increases the electron leakage via the V-pits to the p layer, resulting in an unsatisfactory improvement of IQE. In order to settle out this issue, the AlN hole blocking layer in the n region (HBLN) is designed in the sidewall of the V-pit. It is found that the HBLN can not only alleviate the electron leakage via the V-pits to the p layer, more importantly, but also block the hole leakage via the V-pits to the n layer, leading to the improvement of IQE.
24 February 2020 in Chinese Physics B
It is observed that the radiative recombination rate in InGaN-based light-emitting diode decreases with lattice temperature increasing. The effect of lattice temperature on the radiative recombination rate tends to be stable at high injection. Thus, there should be an upper limit for the radiative recombination rate in the quantum well with the carrier concentration increasing, even under the same lattice temperature. A modified and easily used ABC-model is proposed. It describes that the slope of the radiative recombination rate gradually decreases to zero, and further reaches a negative value in a small range of lattice temperature increasing. These provide a new insight into understanding the dependence of the radiative recombination rate on lattice temperature and carrier concentration in InGaN-based light-emitting diode.