The effect of plasticizer on dielectric properties of poly(methyl methacrylate) (PMMA)/titanium dioxide (TiO2) composites was investigated. Propylene carbonate (PC) was used as plasticizer in the samples which were prepared with the conventional solvent casting technique. Scanning Electron Microscopy with Energy Dispersive X-Ray Analysis (SEM-EDX) and Differential scanning calorimetry (DSC) analyses and LCR Meter measurements (performed between 300 K and 400 K), were conducted to examine the properties of the composites. With the addition of plasticizer, the thermal properties have changed and the dielectric constant of the composite has increased significantly. The glass transition temperature of pure PMMA measured 121.7°C and this value did not change significantly with the addition of TiO2, however, 112°C was measured in the sample with the addition 4 ml of PC. While the dielectric constant of pure PMMA was 3.64, the ε′ value increased to 5.66 with the addition of TiO2 and reached 12.6 with the addition of 4 ml PC. These changes have been attributed to increase in amorphous ratio that facilitates polymer dipolar and segmental mobility.
23 February 2024 in Colloids and Surfaces A: Physicochemical and Engineering Aspects
New 2,5-di(thiophen-2-yl)furan-3-carbonitriles as thiophene–furan–thiophene type monomers (2a and 2b) were synthesized by the oxidation of 2,5-di(thiophen-2-yl)-4,5-dihydrofuran-3-carbonitriles which were prepared by the reaction of 3-oxopropanenitriles with alkenes mediated with manganese(III) acetate using DDQ (2,3-dichloro-5,6-dicyano-p-benzoquinone). The monomers and their copolymers with EDOT were electrochemically polymerized in acetonitrile (AN)/LiClO4. The electrochemical, spectroelectrochemical and morphological properties of the resulting polymer and copolymer films were investigated by cyclic voltammetry, UV-visible spectroscopy and atomic force microscopy. Observed differences in cyclic voltammetry, UV-vis spectroscopy and neutral state absorption (π–π* transition) have been accepted as evidence for the copolymerization. Copolymer films have distinct electrochromic properties according to superposition of the contained polymer properties. In addition the dissolution problem that's causing the instability of poly2b has been fixed with copolymerization. Switch time measurements showed that copolymer films are candidates for ECD applications due to their stability, fast response time and good optical contrast.
10 October 2011 in Journal of Applied Polymer Science
Using biological/renewable resources as filler or modifier in both thermoplastics and rubbers has been of a great interest in order to reduce negative effects of traditional petroleum/natural gas based fillers. In this study, the main goal was the use of spent (waste) coffee grounds as a natural alternative filler to carbon black in acrylonitrile butadiene rubber (NBR) based compounds. Stabilization effect of fresh coffee grounds was also investigated. Both fresh and spent coffee grounds were gradually replaced with CB in a reference (control) NBR compound formulation. Rheological, physico-mechanical, thermal, morphological, and dielectric properties of the biocomposites were tested and compared with the control. Processability has been affected positively in the case of using coffee grounds thanks to the presence of triacyl groups in coffee. Improved abrasion resistance and lower oil swelling could be obtained for coffee containing compounds. In conclusion, spent coffee grounds were found to be a good natural alternative filler for preparing NBR based biocomposites without a significant change in material properties.