4 July 2022 in Phytochemistry
16 May 2024 in IEEE Transactions on Plasma Science
For revealing the effects of gas components on the plasma jet characteristics, the corresponding jet characteristics of a home-made thermal plasma torch working with various gas components were experimentally studied by using the orthogonal test method. The experimental results showed that: 1) When nitrogen (N $_{2})$ is defined as the main working gas, the arc voltage, working power, thermal efficiency, and mean specific enthalpy all decrease with increasing argon (Ar). With the increase of helium (He), the mean specific enthalpy first decreases and then increases, while other three jet characteristics decrease. With the increase of hydrogen (H $_{2})$ , the arc voltage and working power increase, while the thermal efficiency and mean specific enthalpy decrease. 2) When Ar is defined as the main working gas, the mentioned four jet characteristics all increase with N $_{2}$ . With the increase of He, the thermal efficiency decreases, while other three jet characteristics increase. With the increase of H $_{2}$ , the arc voltage and working power increases, while the mean specific enthalpy varies little and the thermal efficiency decreases. 3) Besides, the gas volume percentage of the gas component is the uppermost influence factor of the jet characteristics.
8 July 2025 in IEEE Transactions on Plasma Science
The high-quality aluminum nitride (AlN) powder is always prepared industrially by using the direct nitriding and carbothermic reduction method at present. However, considering their disadvantages of these methods, such as low production efficiency and complex post-treatment process, alternative preparation techniques should be considered. For generating the AlN powder, there are three main factors that should be considered: high temperature, aluminum (Al), and nitrogen (N2) resources. Considering the rich N+ resource and high temperature in the laminar plasma jet (LPJ), the Al powder could be injected into the LPJ to prepare the AlN powder. For improving the quality of the prepared AlN powder, the interaction mechanism of the flow characteristics and heat transfer between the Al powder and the LPJ should be considered. Therefore, the interaction mechanism between LPJ and Al powder was explored based on the discrete phase model (DPM) built into Fluent. With this simulation model, the flow characteristics and heat transfer between the Al powder and the LPJ under various working conditions were studied. The results of this work are summarized as follows. With the increase of the LPJ power, powder feeding angle, the carrier gas flow rate, and powder feeding rate, more Al powder reaches its synthesis temperature area, which may lead to a higher purity of the prepared AlN powder.