Key Laboratory of Theoretical Chemistry of Environment, Ministry of Education, School of Chemistry, South China Normal University, Guangzhou, People’s Republic of China
Auto-generated profile, based on publicly available information
Zhi Zeng
Key Laboratory of Theoretical Chemistry of Environment, Ministry of Education, School of Chemistry, South China Normal University, Guangzhou, People’s Republic of China
A novel porous polymer material with red emissions composed of a europium silica hybrid and polyurethane foam has been assembled. Its sensing properties in water have been investigated and the fluorescence of the foam was selectively quenched in the presence of Cu2+ (detection limit 3.4 μM) compared with other cation ions (Li+, Na+, K+, Mg2+, Ca2+, Ba2+, Cr2+, Mn2+, Co2+, Ni2+, Zn2+, Cd2+, Hg2+, Al3+, Pb2+ and Ag+). The high selectivity and sensitivity were attributed to the strong chelation of Cu2+ with nitrogen atoms of the ligand (L) and the photo-induced electron transfer effect. The luminescent polyurethane foam showed a good reusability (more than 10 times). Interestingly, the red emission can be switched “off” and “on” via the addition of copper ions and EDTA, respectively. Additionally, the tensile failure tests proved that higher mechanical strength could be achieved in the silica material reinforced polyurethane foam.
5 December 2019 in Journal of Nanoparticle Research
The chemical compositions of volatile components from Magnolia biondii Pamp were determined by steam distillation (SD) and headspace solid phase micro-extraction (HS-SPME) followed by gas chromatography (GC) and gas chromatography-mass spectrometry (GC-MS) analysis. Fifty-six compounds were identified and the major volatile components were d-camphor (0.18-43.26%), 1,8-cineol (13.23-38.02%), α-terpineol (6.57-12.29%) and α-cadinene (5.53-15.15%). The comparison of the volatile components from M. biondii Pamp harvested in three regions of China was investigated. Also, the comparison of volatile components by SD and HS-SPME methods in term of isolation time, plant-consuming and chemical compositions was discussed as well. The percentages of the volatile components by HS-SPME method were found to be large difference from the corresponding one by SD method. HS-SPME technique was much faster than SD (60 min (HS-SPME)/420 min (SD)). Although the aromatic profiles between HS-SPME and SD methods showed several quantitative differences, HS-SPME may be applied routinely to analyze aromatic and medicinal plants.