Defeng Lang

Defeng Lang

Auto-generated profile, based on publicly available information

Defeng Lang

SKF Research and Technology Development

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 July 2017 in Tribology Transactions
Verified
Journal Article
Open access
NDNicholas Dittes
Nicholas Dittes
APAnders Pettersson
Anders Pettersson
PMPär Marklund
Pär Marklund
DLDefeng Lang
Defeng Lang
PLPiet Lugt
Piet Lugt
The temperature dependence on the dielectric properties of water-contaminated grease is investigated in this article. The purpose of this investigation was to identify the dielectric properties that could be measured to differentiate varying levels of water contamination in calcium sulfonate complex (CaS-X) grease with three different test cells with the purpose of eventually developing a grease condition sensor. Measuring the change in dielectric constant over a small temperature change yielded useful estimations of water content and amount of grease where the added water content ranged from 0.22% to about 5.5%. Additionally, other parameters such as incomplete fill/coverage of the sensors were investigated as a prestudy. The results from this set of experiments show that the measurement has potential to be developed into a condition monitoring sensor in the future.

1 January 2023 in Tribology and Materials
Verified
Journal Article
Open access
MGMarcus Gaertner
Marcus Gaertner
CBChristian Brecher
Christian Brecher
SNStephan Neus
Stephan Neus
LCLeonardo Catana
Leonardo Catana
TSTurin Skf Industrie S.P.A.
Turin Skf Industrie S.P.A.
DLDefeng Lang
Defeng Lang
The further development of high-precision bearings regarding higher speeds and load-carrying capacity is becoming increasingly challenging. One approach to meet the increased requirements is to use new high-performance raceway steels. Particularly for a highly stressed lubricant film, where seizure may occur, the bearing material properties can make a key contribution in increasing the lifetime. In the following, the test results of hybrid spindle bearings of type 7008 made of nitriding steel are analysed. The bearings were tested in an endurance run for a constant speed parameter of 2.5 million ndm and a maximum contact stress of 2,900 MPa at the inner ring contact. The operational behaviour was validated based on the bearing outer ring temperature and the acceleration level in the test rig. A further sample test in endurance runs with an increased speed parameter of 2.8 million ndm and a maximum contact stress of 3,200 MPa at the inner ring shows that the performance limit of the bearing is even higher than initially assumed. The microscope analyses of the bearing steels after the test show low wear. An analysis of the test conditions in terms of contact stresses, lifetime and the pv value illustrates that the bearings can run far above standard conditions. The experimental results show that the operational limits of hybrid spindle bearings with a raceway made of nitriding steels are significantly higher than expected.

31 August 2026 in Tribology Transactions
Verified
Journal Article
Closed access
JWJun Wang
Jun Wang
BLBela Lehnhardt
Bela Lehnhardt
VSVolker Schneider
Volker Schneider
DLDefeng Lang
Defeng Lang
KKKoji Kaneko
Koji Kaneko
FGFeliciano Greco
Feliciano Greco
Minimum oil lubrication is a method in which a precisely controlled, minimal amount of lubricant is provided directly to the tribological interfaces. (1) In rolling bearing applications, minimum oi...