1 November 2018 in Journal of Cultural Heritage
12 February 2025 in Journal of Building Engineering
21 July 2023 in Materials Science Forum
Due to economic, sustainable, and aesthetic benefits, academia and the construction industry are exploring the use of earth in modern construction is being widely studied. Unfortunately, earth as a construction material has low mechanical, poor water durability resistance, and the potential to swell and crack. Therefore, this paper evaluates chitosan and potato starch, natural biodegradable polymers, as stabilizers to improve mechanical strength and water durability resistance of printable earth-based matrix reinforced with sisal fibers. Although the test results indicated that the chitosan had a better performance as an earth stabilizer than potato starch, adding both stabilizers resulted in earthen composites with higher compressive strength and lower water permeability. These results demonstrate the feasibility of using natural stabilizers to improve the performance of earth-based materials for 3D printing without affecting their printability capacities.
21 July 2023 in Materials Science Forum
Soil as a building material is gaining renewed interest from academia, and the construction sector, mainly for fabricating low-environmental impact homes. The fabrication of houses with soil using traditional methods such as adobe, cob, and rammed earth dates back to ancient times. However, emerging construction technologies, such as 3D printing, can be compatible with this material for building purposes. The article presents the validation of a 3D printing system for construction applications and the evaluation of soil-cement matrices' printability. First, the paper defines the printing parameters through experimental testing on soil matrices. Then, the article evaluates the printability of soil-cement matrices through filament printing and stacking tests. The results show that the 3D printing system prototype can fabricate small and medium-sized elements with soil matrices after correctly defining the pumping speed, printing speed, and layer height. Furthermore, experimental printing test results demonstrate that soil-cement matrices can be easily extruded and stacked; however, their printability capacity is strongly affected by the total water content and printing speed. This research highlights the suitability of soil-cement mixtures for additive manufacturing, a promising outcome that can facilitate the construction of homes in remote areas using 3D printing systems.
1 February 2022 in KSCE Journal of Civil Engineering
An experimental study was performed to investigate the dissipated energy to failure of sand samples subjected to uniform and non-uniform cyclic simple shear loading. The hypothesis evaluated was that for a given initial sample state the specific dissipated energy required to reach failure should be reasonably constant independent of the type of stress-time history used in the testing. Test samples consisted of dry Ottawa sand prepared at nine different initial states that were subjected to different stress controlled cyclic horizontal shear loading waveforms that included 15 uniform sinusoidal waves and up to 33 non-uniform loading wave forms. The experimental program presented showed that the measured cumulative dissipated specific energy to failure, defined when the double amplitude shear strain reaches 7.5%, for the different sample initial states was reasonably constant but with coefficients of variation ranging between 13 to 44%. As expected, the cumulative dissipated energy increased with increasing initial stress level and relative density. The findings support the notion that specific dissipated energy can be used as a reasonable failure predictor for uniform dry sands based on their initial state and are independent of the type of cyclic simple shear loading waveform using in the testing.