As a low-head and non-drive pump, the head reduction and stall advance are the key factors that restrict the popularization and application of the full tubular pump (FTP). In this paper, the shear stress transport (SST) k-ω turbulence model is used for the numerical calculation of the FTP. Additionally, based on the entropy generation theory, the energy loss and main distribution zones of the FTP under all working conditions are analyzed, and the mechanism of inducing its stall advance is explored. By comparison, we found that there is little difference between the numerical simulation results and the model test. Turbulence entropy generation has a high proportion under small flow conditions, which is mainly reflected in the outlet flow separation zone of the suction surface of the impeller blade, the guide vane inlet zone where inlet deviation exists, and the trailing edge of the guide vane where the flow separation exists. Compared with the axial flow pump (AFP), when the flow rate decreases, the clearance reflow between the stator and rotor induces the deterioration of the flow at the impeller inlet, and the turbulent entropy generation in the impeller channel increases rapidly, making the FTP enter the stall zone ahead of time. The clearance backflow affects the flow pattern of the inlet pipe, making the turbulence entropy generation in the outlet area of the inlet pipe increase. The total entropy generation in the stator–rotor region is little affected by the pump flow conditions, and it is mainly affected by different stator–rotor backflow clearance dimensions. This study can provide a reference for exploring the energy loss of the FTP and revealing its stall characteristics.
In this study, an analysis of a low-specific-speed pump is carried out based on the methods of one-way and two-way fluid–structure interactions (FSIs). This study analyzes the influence of FSIs on the internal flow field and external characteristics of the pump. Utilizing a two-way FSI, the signal coherence analysis method is employed to analyze the coherence of signals between the flow field and the structural field. Addressing the issue of a lack of a connection between the two signals, this study bridges a gap in the existing research. The results indicate that different interaction methods have certain influences on impeller stress and deformation. However, in both coupling modes, the maximum deformation and the maximum equivalent stress have the same distribution position. The head error obtained using the two-way coupling method is lower than that of the uncoupled results, which indicates that the two-way FSI calculation results are closer to the experimental results. The pressure pulsation signals at the interface of the impeller and volute exhibit strong coherence with the structural field signals. For low-specific-speed centrifugal pumps, establishing a clear connection between the flow field signals and structural field signals will help guide further optimization of their performance through design.