The dynamics of the wake behind a flat-back Ahmed body are modified using a large-scale fluidic oscillator, aiming at drag reduction and the reflectional symmetry breaking (RSB) mode suppression. In the present experiment, the sweeping jet (SWJ) actuator is integrated into the base of the bluff body such that its nozzle width corresponds to about 2/3 of the bluff body base width. The jet is sweeping in the horizontal plane, which coincides with the plane of the wake flow state switching due to the RSB mode. The impact of the SWJ actuator is evaluated for three different locations along the base's height, and for a range of blowing coefficients. The base suction coefficient is recorded from four pressure measurements at the base, while the drag coefficient is obtained from direct force and moment measurements. Particle image velocimetry of the near wake reveals the modifications of the mean flow, which elucidate on the changes in the base suction and drag coefficients. Both drag reduction and RSB mode suppression are achieved, however, not for the same blowing coefficient. The symmetrized wake yields a near Gaussian distribution of the base pressure gradients around zero in both gy and gz directions. This result is corroborated by the joint probability distributions of pitching and yawing moment fluctuations from force balance measurements.
1 July 2015 in International Journal of Heat and Mass Transfer
This paper presents an experimental and numerical study of the sweeping jet oscillation frequency which is a crucial parameter for effective separation control. Measurements of the time-resolved static pressure are made in the feedback channels using high-frequency pressure transducers. Experiments are performed for eight different inlet mass flow rates (from 1g/s to 8 g/s). The effects of geometry scaling are examined for the halfand double-size of the baseline actuator. The results reveal a relationship between the oscillating frequency and the inlet mass flow rate and demonstrate a linear trend of the Strouhal number versus the inlet Mach number for all the geometries. The experimental results are compared to results obtained from numerical simulations using Ansys Fluent v17.2 software.A high correspondence is found between experimental results and numerical data from computationally inexpensive 2D-URANS simulations. This result opens possibilities of using these simple numerical models to perform extensive studies of the geometric parameters of the sweeping jet actuator in the future.