NbO2 is a promising candidate for resistive switching devices due to an insulator-metal transition above room temperature, which is related to a phase transition from a distorted rutile structure to an undistorted one. However, the electrical resistivity of the NbO2 thin films produced so far has been too low to achieve high on-off switching ratios. Here, we report on the structural, electrical, and optical characterization of single-crystalline NbO2 (001) thin films grown by pulsed laser deposition on MgF2 (001) substrates. An annealing step reduced the full width at half maximum of the NbO2 (004) x-ray Bragg reflection by one order of magnitude, while the electrical resistivity of the films increased by two orders of magnitude to about 1 kΩcm at room temperature. Temperature-dependent resistivity measurements of an annealed sample revealed that below 650 K, two deep-level defects with activation energies of 0.25 eV and 0.37 eV dominate the conduction, while above 650 K, intrinsic conduction prevails. Optical characterization by spectroscopic ellipsometry and by absorption measurements with the electric field vector of the incident light perpendicular to the c-axis of the distorted rutile structure indicates the onset of fundamental absorption at about 0.76 eV at room temperature, while at 4 K, the onset shifts to 0.85 eV. These optical transitions are interpreted to take place across the theoretically predicted indirect bandgap of distorted rutile NbO2.
We investigated thin films grown by pulsed-laser deposition on (0001) substrates. Increasing the growth temperature from 700 to , a clear improvement of the structural quality and the interface abruptness has been observed for the epitaxial films, together with an increase in the average grain size from tens of nanometers to above 100 nm. For achieving high film resistivities, increasing the average grain size is found to be crucial. For a more detailed investigation of the carrier transport characteristics, Raman spectroscopy is demonstrated as a powerful tool. In the case of relatively large grain sizes, we reveal that the film resistivities directly correlate with the carrier concentration in the grains. The results obtained for comparatively small grain sizes can be explained by carrier transport via a percolation mechanism along metallic grain boundaries in accordance with a previously reported model.