Martha L. Mora Bejarano

Martha L. Mora Bejarano

Auto-generated profile, based on publicly available information

Martha L. Mora Bejarano

Instituto de Pesquisas Energéticas e Nucleares (IPEN)/CNEN-SP, Avenida Professor Lineu Prestes 2242, Cidade Universitária, São Paulo, São Paulo 05508-000, Brazil

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
3 March 2009 in Journal of Fuel Cell Science and Technology
Verified
Journal Article
Closed access
PDF file
AAAlexandre B. Andrade
Alexandre B. Andrade
MBMartha L. Mora Bejarano
Martha L. Mora Bejarano
ECEdgar F. Cunha
Edgar F. Cunha
EREric Robalinho
Eric Robalinho
MLMarcelo Linardi
Marcelo Linardi
A sieve printing technique has been developed for the preparation of gas diffusion electrodes for proton exchange membrane fuel cells (PEMFCs). The results of the preparation of membrane electrode assemblies (MEAs) are shown to be faster and highly reproducible by using the sieve printing and hot pressing method. These results were compared with those obtained by spray and hot pressing method. The experiments were carried out in a 25 cm2 single PEM fuel cell with platinum loadings of 0.4 mg Pt cm−2 and 0.6 mg Pt cm−2 on the anode and cathode, respectively. Scanning electron microscopy analysis was used to investigate the electrodes’ morphology. The performance of the MEAs was measured by polarization curves. It was observed that the sieve printing technique is highly reproducible and significantly more accurate and faster than the spray one. Sieve printing technique can be easily scaled up and is very adequate for high volume production with low-cost. Such features allow manufacturing large active areas for power stack fabrication. In addition, this deposition technique has produced MEAs with a 39.8% higher power density at 0.6 V when compared with the spray one.