We demonstrate the fabrication and characterization of high‐efficiency, single‐junction p‐i‐n GaAs solar cells, on flexible metal foil with epi‐ready buffer via roll‐to‐roll fabrication. Single‐junction p‐i‐n GaAs solar cells were fabricated using metal–organic chemical vapor deposition (MOCVD). An efficiency greater than 13% was obtained at 1 sun, which is the highest reported efficiency on GaAs photovoltaics directly deposited on metal tapes. This exceeds our previously reported study showcasing 11.5% efficiency on single‐junction p‐n solar cell structure. Improved morphology of p‐i‐n structure compared with p‐n is explained by atomic force microscopy (AFM), scanning electron microscopy (SEM), and helium ion microscopy (HIM) measurements. Time‐of‐flight secondary ion mass spectrometry (TOF‐SIMS) analysis showed reduced Zn diffusion in p‐i‐n cell compared with the p‐n cell. We attribute the improvement in efficiency of p‐i‐n cells on flexible metal tapes to the quality of the junction, surface morphology, controlled diffusion of species within the active layers, and increase in absorption due to the optimized intrinsic layer thickness.
We demonstrate flexible single-junction III-V solar cells based on single-crystal-like GaAs thin films directly grown on a metal tape. The epitaxial (Al)GaAs thin-film structures are developed on flexible polycrystalline Hastelloy tapes using crystallinity-transformational buffer layers for photovoltaic devices with front illumination geometry. The GaAs solar cell shows promising photovoltaic characteristics under AM 1.5G 1-Sun illumination. An open-circuit voltage of 330mV, a short circuit current of 21mA/cm 2 , and a fill factor of 73 result in a conversion efficiency of ~5%. Further improvement in semiconductor thin films quality, device design and fabrication process optimization would improve the device performance characteristics. This new technology has the potential for next-generation low-cost and high efficiency flexible photovoltaic devices.