Integrating safety features to cut off excessive current during accidental internal short circuits in Li-ion batteries (LIBs) can reduce the risk of thermal runaway. However, making this concept practical requires overcoming challenges in both material development and scalable manufacturing. Here, we demonstrate the roll-to-roll production of a safety reinforced layer (SRL) on current collectors at a rate of 5 km per day. The SRL, made of molecularly engineered polythiophene (PTh) and carbon additives, interrupts current flow during voltage drops or overheating without adversely affecting battery performance. Impact testing on 3.4-Ah pouch cells shows that the SRL reduces battery explosions from 63% to 10%. This work underscores the potential of integrating material science with manufacturing technology to enhance battery safety.
Herein, we have demonstrated a highly efficient, flexible, and low-cost (Pt-free and TCO-free) counter electrode made of a highly conductive poly(3,4-ethylene dioxythiophene) (PEDOT)/exfoliated graphite (EFG) composite in solid state dye-sensitized solar cells (DSSCs) employing polymer electrolytes. Electropolymerized one-dimensional PEDOT nanofibers were firmly attached to a flexible EFG sheet affording high catalytic activity and electron conductivity. PEDOT/EFG counter electrode-based DSSCs showed an energy conversion efficiency of 5.7% with a solid polymer electrolyte, which is significantly higher than conventional Pt electrodes (4.4%) under similar device architecture conditions.