The most important model catalytic reaction to test the catalytic activity of metal nanoparticles is the reduction of 4-nitrophenol to 4-aminophenol by sodium borohydride as it can be precisely monitored by UV–vis spectroscopy with high accuracy. This work presents the catalytic reduction of 4-nitrophenol (4-Nip) to 4-aminophenol (4-Amp) in the presence of Pd nanoparticles and sodium borohydride as reductants in water. We first evaluate the kinetics using classical pseudo first-order kinetics. We report the effects of different initial 4-Nip and NaBH4 concentrations, reaction temperatures, and mass of Pd nanoparticles used for catalytic reduction. The thermodynamic parameters (activation energy, enthalpy, and entropy) were also determined. Results show that the kinetics are highly dependent on the reactant ratio and that pseudo first-order simplification is not always fit to describe the kinetics of the reaction. Assuming that all steps of this reaction proceed only on the surface of Pd nanoparticles, we applied a Langmuir−Hinshelwood model to describe the kinetics of the reaction. Experimental data of the decay rate of 4-nitrophenol were successfully fitted to the theoretical values obtained from the Langmuir–Hinshelwood model and all thermodynamic parameters, the true rate constant k, as well as the adsorption constants of 4-Nip, and BH4− (K4-Nip and KBH4−) were determined for each temperature.
Furfural has become one of the most promising building blocks directly derived from biomass. It can be transformed into numerous important biobased chemicals. Among them, furfuryl ethers such as furfuryl ethyl ether (FEE) and tetrahydrofurfuryl ethyl ether (THFEE) are considered to be attractive derivatives, notably as fuel components, due to their high stability and high octane numbers. Therefore, the production of furfuryl ethers from furfural via a hydrogenation route is an important academic and industrial challenge and requires the deployment of new catalytic processes under green and competitive reaction conditions. The existing processes are based on a two-step process combining hydrogenation and reaction with a strong Bronsted acid catalyst in batch conditions. For the first time, a continuous flow one-step process has been elaborated for the conversion of furfural directly into furfuryl ethers based on reductive etherification. The present work explores the catalytic performance in a continuous flow of commercial palladium catalysts supported on activated carbon for the catalytic reductive etherification of furfural with ethanol in the presence of trifluoroacetic acid. The chemical and engineering aspects, such as the mechanisms and reaction conditions, will be discussed.
1 January 2022 in Journal of Hazardous, Toxic, and Radioactive Waste
Sorghum stems will be considered in this work as an alternative for the adsorption of cyanides in aqueous solution. It is an abundant material in southern Algeria, and it does not require any specific pretreatment. Therefore, it is a much cheaper adsorbent than the adsorbents usually used for cyanide adsorption, such as activated carbon. In this work, a complete study will be presented that includes the physicochemical characterization of prepared sorghum stem particles (SSPs) and the kinetic and thermodynamic adsorption studies. The pseudo-second-order kinetic model best described the experimental data with a high coefficient of determination and that the Langmuir isotherm model fitted better than the Freundlich and Temkin models. The Langmuir maximum adsorption capacity (qm) was 76.92 mg/g at 293 K. The thermodynamic study showed that the adsorption of cyanides on SSPs was endothermic and spontaneous and that it was chemisorption. The comparison with the usual adsorbents tested by other authors showed that SSP could be an interesting candidate due to its high adsorption capacity and easy preparation.