22 March 2012 in Journal of Thermoplastic Composite Materials
With increasing environmental awareness and ecological risk, green composites have gained more and more research attention, as they have the potential to be attractive than the traditional petroleum-based composites which are toxic and nonbiodegradable. Because of their lightweight, friendly processing and acoustic insulation, green composites have been used widely ranging from aerospace sector to household applications. The end-of-life concern with many polymeric composites has also limited their application spectrum. The green composites not only replace the traditional materials such as steel and wood but also challenge certain nonbiodegradable polymer composites. The present research initiative aims at highlighting the issues and challenges in the development and characterization of poly lactic acid–based green composites. A few of these important composites and their mechanical properties (tensile, compressive, flexural, and impact strength) have been reported in this study. The focus is the identification of the possible areas for their novel applications. A study has been conducted to categorize the various types of green composites on the basis of their physical, chemical, and mechanical characteristics.
24 October 2012 in Journal of Reinforced Plastics and Composites
In this study, natural fiber reinforced polylactic acid composites have been developed by hot pressing through film-stacking procedure. The reinforcement materials used are nettle, Grewia optiva and sisal fibers in the plain weave form. For comparison purposes, polypropylene-based composites using the same fibers have also been developed. Mechanical properties (tensile, compressive, flexural, and impact properties) of all the developed composites have been evaluated through standard test procedures. It has been found that the polylactic acid based composites have superior mechanical properties and can be a potential substitute for traditional synthetic fiber composites in many application areas. Polylactic acid/sisal composite showed overall the best performance in terms of mechanical behavior. The morphological study of the fractured surface during mechanical testing has been done using scanning electron microscopy, which provides the mechanism of failure of composites during different types of mechanical loadings.
1 January 2008 in Materials & Design (1980-2015)
1 April 2013 in Composites Part B: Engineering
8 August 2014 in Materials and Manufacturing Processes
Natural fiber composites have attracted global attention due to their lightweight, low-carbon footprint characteristics as well as good mechanical properties. Due to these distinct advantages, the application spectrum of these composites has grown at an unprecedented rate. These composites are used for making a wide variety of sophisticated engineering products; therefore, certain degree of machining operations is necessary for assembly purposes. Drilling is an indispensable machining operation that is frequently performed for making of holes to facilitate assembly of several components into an intricate part. In the present research endeavor, the drilling behavior of unidirectional sisal-epoxy and sisal-polypropylene composite laminates has been experimentally investigated. Chip formation characteristics in the context of both thermoset and thermoplastic natural fiber composite laminates have been discussed. Further, the analysis of drilling force signals has been reported and the mapping of drilling forces has been proposed. Influence of drill geometry, feed, and spindle speed on drilling forces and a comparative analysis of damage characteristics of drilled hole have also been reported. From the current research work, it has been established that the tooling requirement for drilling of composite laminates under investigation is substantially different.