25 July 2022 in Applied Physics Letters
Ultra-small micro-LEDs are essential for next-generation display technology. However, micro-LEDs below 5 μm have been seldom reported. In this work, we demonstrate InGaN-based blue and green micro-LEDs from 1 to 20 μm by using laser direct writing lithography. The 1-μm blue micro-LEDs show a peak external quantum efficiency of 13.02%, which is 9.57% for green ones. By characterizing the size-dependent external quantum efficiency and simply assuming that this variety is dominantly determined by the dry-etching induced dead zone, we deduce that the dead zone sizes of carrier injection at the edge of chips are 0.18 and 0.15 μm in blue and green ones, respectively. A time-resolved photoluminescence measurement also shows that carrier lifetime reduction at the edge of blue ones is more serious than that of green ones, reflecting the easier carrier lateral diffusion in the former than the latter. These results exhibit the ability of laser direct writing lithography on micro-LED fabrication and also provide a reference for predicting the limit of their chip size scaling-down.
22 December 2021 in Semiconductor Science and Technology
Due to spectrum shortage, visible light communication (VLC) has gradually been regarded as an important alternative and reinforcement in wireless communication field. Micro-light-emitting diodes (micro-LEDs) are ideal high-speed light sources for VLC due to its significantly improved modulation bandwidth. In this review, the developments of high-speed micro-LEDs in VLC are discussed. While expounding the unique advantages of micro-LED, we also point out the existing problems and challenges. On this basis, we review the outstanding achievements in bandwidth improvement, and also look forward to some promising directions for future research.
4 December 2023 in Applied Physics Letters
The ultra-small size InGaN red micro-LED has attracted a lot of research interest for AR micro-display applications. However, it still faces the challenge of maintaining the emission wavelength and efficiency that meet the needs of micro-display in small size and high current density. Here, we demonstrate 1–20 μm InGaN red micro-LEDs based on freestanding GaN substrates, showing enhanced indium incorporation compared with those grown on traditional sapphire substrates. For the 1 μm devices, an external quantum efficiency (on-wafer) of 0.86% and a wavelength of 613.6 nm are achieved at a current density of 50 A/cm2. In addition, the emission uniformity of 1 μm array grown on GaN substrates is significantly superior to that grown on sapphire substrates. These results indicate that freestanding GaN substrates are benefits for improving performance of red InGaN micro-LEDs.
25 July 2022 in Optical Materials Express
Micro-scale light-emitting diodes (micro-LEDs) are regarded as the next generation display technology. Compared to blue and green ones, InGaN-based red micro-LEDs require higher indium composition in their active region, which is quite challenging for material growth. Here, high-indium-composition InGaN quantum dots (QDs) with a density of 3 × 1010 cm-2 are self-assembly grown by metal-organic vapor phase epitaxy (MOVPE) based on a precursor-alternate-admittance method. The growth mechanism is systematically studied, and consequently a 613-nm red QDs sample with an internal quantum efficiency (IQE) of 12% is demonstrated. Furthermore, when micro-LEDs based on these red InGaN QDs with a chip size of 1-20 µm are fabricated, an electroluminescence blueshift to yellow and green is observed. The 20-µm and 1-µm micro-LEDs show 4.92% and 1.78% external quantum efficiency (EQE) at 0.3 and 20 A/cm2, respectively. By introducing multiple quantum wells (MQWs) pre-strained layer beneath the QD layers, a 10-µm micro-LED with 638 nm emission wavelength is demonstrated, with a price of reduced EQE to 0.03% at 10 A/cm2.
1 October 2024 in APL Photonics
Micro-scale light-emitting diodes (micro-LEDs) have received widespread attention in recent years for applications in display and optical communication. Compared with conventional quantum well active regions, quantum dots (QDs) can increase the carrier concentration at the same current density, which is beneficial for improving the efficiency and bandwidth of LEDs at low current densities. This is exactly what micro-LEDs need for display and communication applications. In this Perspective, we give a general introduction to InGaN QDs and provide an overview of the growth of InGaN QDs by metal-organic chemical vapor deposition. We then discuss the advances in green and red micro-LEDs based on InGaN QDs for display applications. This is followed by recent progress on high-speed blue micro-LEDs, which have great potential for use in chip-to-chip optical interconnections. Finally, we address the remaining challenges for a further improvement in InGaN QD-based micro-LEDs.
26 August 2024 in Applied Physics Letters
The size-dependent emission wavelength shift of micro-scale light emitting diodes (micro-LEDs) has been frequently reported in recent publications, but its underlying physical mechanism has not yet been thoroughly elucidated. Here, we fabricate and characterize the red, green, and blue InGaN micro-LED mesas with different diameters down to 1 μm. As the size decreases, all the samples of different colors show an inverted V-shaped photoluminescence wavelength variation trend, first a red shift and then a blue shift, and the shifting range is larger for samples with longer wavelengths. Micro-Raman spectrum confirms that the stress was significantly released after scaling down the size from epitaxial wafer to 1 μm. The theoretical simulations show that the red and blue shifts are, respectively, attributed to the bandgap narrowing and the weakening of the quantum-confined Stark effect caused by strain relaxation, which dominate successively.