1 May 1996 in Physics of Plasmas
Because alpha particle losses can have a significant influence on tokamak reactor viability, the loss of deuterium–tritium alpha particles from the Tokamak Fusion Test Reactor (TFTR) [K. M. McGuire et al., Phys. Plasmas 2, 2176 (1995)] has been measured under a wide range of conditions. In TFTR, first orbit loss and stochastic toroidal field ripple diffusion are always present. Other losses can arise due to magnetohydrodynamic instabilities or due to waves in the ion cyclotron range of frequencies. No alpha particle losses have yet been seen due to collective instabilities driven by alphas. Ion Bernstein waves can drive large losses of fast ions from TFTR, and details of those losses support one element of the alpha energy channeling scenario.
1 January 2020 in Physics of Plasmas
Gas puff Z-pinches are intense sources of X-rays and neutrons but are highly susceptible to the magneto-Rayleigh-Taylor instability (MRTI). MRTI mitigation is critical for optimal and reproducible yields, motivating significant attention toward various potential mitigation mechanisms. One such approach is the external application of an axial magnetic field, which will be discussed here in the context of recent experiments on the Zebra generator (1 MA, 100 ns) at the University of Nevada, Reno. In these experiments, an annular Kr gas liner is imploded onto an on-axis deuterium target with a pre-embedded axial magnetic field ranging from 0 to 0.3 T. The effect of on the stability of the Kr liner is evaluated with measurements of plasma radius, overall instability amplitude, and dominant instability wavelength at different times obtained from time-gated extreme ultraviolet pinhole images. It was observed that the external axial magnetic field does not affect the implosion velocity significantly and that it reduces the overall instability amplitude and the presence of short-wavelength modes, indicating improved pinch stability and reproducibility. For the highest applied T, the stagnation radius measured via visible streak images was found to increase. These findings are consistent with experiments reported in the literature, but here, the required for stability, (where Ipk is the driver peak current and R0 is the initial radius), is lower. This could be attributed to the smaller load geometry, both radially and axially. Consistent with other experiments, the cause of decreased convergence cannot be explained by the additional axial magnetic pressure and remains an open question.
1 April 2020 in Physics of Plasmas
A staged Z-pinch is a fusion concept where a high atomic number liner compresses a fusion fuel (deuterium–deuterium or deuterium–tritium) target. Here, we report new results from Lagrangian, Eulerian, and Arbitrary Lagrangian–Eulerian simulations, which confirm that, with proper treatment of the vacuum region outside from the pinch, fusion energy production >1 MJ can be expected without alpha heating and significantly higher if alpha heating is included. It is shown that shock waves play an important role in preheating the target plasma and in piling up liner mass at the liner/target interface. This results in higher ram pressure just before the pinch stagnation time and ultimately in higher energy density target plasma.
1 April 2024 in Physics of Plasmas
Z-pinch platforms constitute a promising pathway to fusion energy research. Here, we present a one-dimensional numerical study of the staged Z-pinch (SZP) concept using the FLASH and MACH2 codes. We discuss the verification of the codes using two analytical benchmarks that include Z-pinch-relevant physics, building confidence on the codes' ability to model such experiments. Then, FLASH is used to simulate two different SZP configurations: a xenon gas-puff liner (SZP1*) and a silver solid liner (SZP2). The SZP2 results are compared against previously published MACH2 results, and a new code-to-code comparison on SZP1* is presented. Using an ideal equation of state and analytical transport coefficients, FLASH yields a fuel convergence ratio (CR) of approximately 39 and a mass-averaged fuel ion temperature slightly below 1 keV for the SZP2 scheme, significantly lower than the full-physics MACH2 prediction. For the new SZP1* configuration, full-physics FLASH simulations furnish large and inherently unstable CRs (>300) but achieve fuel ion temperatures of many kilo-electron volts. While MACH2 also predicts high temperatures, the fuel stagnates at a smaller CR. The integrated code-to-code comparison reveals how magnetic insulation, heat conduction, and radiation transport affect platform performance and the feasibility of the SZP concept.
1 November 2021 in Physics of Plasmas
The staged Z-pinch is a potentially transformative magneto-inertial fusion energy concept where a high atomic number liner implodes on a deuterium or deuterium-tritium target using multi-MA pulsed current. Over the past several years, this concept was studied experimentally on 1 MA facilities with argon or krypton gas puffs compressing a magnetized deuterium target. Consistent thermonuclear neutron yield of 1010 per shot was measured with krypton liners. In this paper, we investigate the fusion performance of deuterium targets of varying density undergoing compression with low (beryllium) and high atomic number liners (silver, tantalum) using parameters of the Z pulsed power facility. Silver and tantalum liners create strong shocks that preheat the target plasma above 100 eV and pile up liner material at the liner-target interface. The increased mass density at the interface creates strong ram pressure just before the pinch stagnation time. The target plasma is heated to 2–4 keV, in contrast to the < 0.5 kV temperature calculated for the beryllium case. The high atomic number liners produce neutron yield orders of magnitude higher than the yield from the low atomic number liner.
1 September 1999 in Nuclear Fusion
This paper reviews the physics of fusion alpha particles and energetic neutral beam ions studied in the final phase of TFTR operation, with an emphasis on observations in Reversed magnetic Shear (RS) and Enhanced Reversed Shear (ERS) D-T plasmas. Energy-resolved measurements of the radial profiles of confined, trapped alphas in RS plasmas exhibit reduced core alpha density with increasing alpha energy, in contrast to plasmas with normal monotonic shear. The measured profiles are consistent with predictions of increased alpha loss due to stochastic ripple diffusion and increased first- orbit loss in RS plasmas. In experiments in which a short tritium beam pulse is injected into a deuterium RS plasma, the measured D-T neutron emission is lower than standard predictions assuming first orbit loss and stochastic ripple diffusion of the beam ions. A microwave reflectometer measured the spatial localization of low-toroidal mode number (n), alpha-driven Toroidal Alfvén Eigenmodes (TAEs) in D-T RS discharges. Although the observed ballooning character of the n=4 mode is consistent with predictions of a kinetic-MHD stability code, the observed anti-ballooning nature of the n=2 mode is not. Furthermore, the modeling does not show the observed strong dependence of mode frequency on n. These alpha-driven TAEs do not cause measurable alpha loss in TFTR. Other Alfvén frequency modes with n=2-4 seen in both D-T and D-D ERS and RS discharges are localized to the weak magnetic shear region near qmin. In 10-20% of D-T discharges, normal low-n MHD activity causes alpha loss at levels above the first orbit loss rate.