Ehsan Faegh

Ehsan Faegh

Auto-generated profile, based on publicly available information

Ehsan Faegh

University of South Carolina

Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 March 2020 in ACS Applied Energy Materials
Verified
Journal Article
Closed access
BNBenjamin Ng
Benjamin Ng
PCPaul T. Coman
Paul T. Coman
EFEhsan Faegh
Ehsan Faegh
XPXiong Peng
Xiong Peng
SKStavros Karakalos
Stavros Karakalos
RWRalph E. White
Ralph E. White

10 June 2020 in Batteries & Supercaps
Verified
Journal Article
Closed access
PDF file
EFEhsan Faegh
Ehsan Faegh
BNBenjamin Ng
Benjamin Ng
DHDillon Hayman
Dillon Hayman
WMWilliam Mustain
William Mustain

1 September 2021 in Journal of Power Sources
Verified
Journal Article
Closed access
EFEhsan Faegh
Ehsan Faegh
BNBenjamin Ng
Benjamin Ng
BLBrian Lenhart
Brian Lenhart
SLSaheed Lateef
Saheed Lateef
WMWilliam Mustain
William Mustain

1 February 2022 in Journal of Thermal Engineering
Verified
Journal Article
Closed access
PDF file
PBPooria Behnam
Pooria Behnam
MFMeysam Faegh
Meysam Faegh
IFIman Fakhari
Iman Fakhari
PAPouria Ahmadi
Pouria Ahmadi
EFEhsan Faegh
Ehsan Faegh
Marc RosenMarc Rosen
Marc Rosen
Low-temperature geothermal heat sources have the highest share of geothermal energy in the world. Utilization of these heat sources for energy and freshwater generation can play an important role in meeting energy and freshwater demands. To do so, this study aims to propose a novel trigeneration cycle powered by low-temperature geothermal sources. The proposed system, which is an integration of Kalina and humidification-dehumidification (HDH) cycles, is used for the generation of electricity, heating, and freshwater. For the Kalina cycle, an evaporative condenser is used. It also acts as a humidifier and heater of the humidification-dehumidification desalination cycle, resulting in a reduction in the complexity of the trigeneration system. A comprehensive thermoeconomic analysis and multi-objective optimization of the new trigeneration system are performed. First, a detailed parametric study is carried out to investigate the effects of key design parameters, including turbine inlet pressure, condenser temperature, basic solution ammonia concentration, air mass flow rate and heat source temperature, on the thermoeconomic criteria. Then, a multi-objective optimization is conducted to determine the best design parameters, considering exergy and total cost rate as the objective functions. The optimal solution Pareto frontier indicates that the exergy efficiency and total cost rate vary in the range of 14.9–41.6% and 1.13–2.19 $/h, respectively. Analyses of the scattered distributions of design parameters reveal that lower heat source temperatures tend to optimize the objective functions. However, altering other design parameters has a significant effect on the trade-off between exergy efficiency and total cost rate.

23 November 2020 in ECS Meeting Abstracts
Verified
Journal Article
Closed access
EFEhsan Faegh
Ehsan Faegh
BNBenjamin Ng
Benjamin Ng
WMWilliam Mustain
William Mustain
For decades, aluminum anodes have been looked at as the holy grail for many battery chemistry platforms, promising to increase the gravimetric and volumetric energy density to new heights while keeping battery costs low. However, its deployment has been beset with problems, the most notable of which have been corrosion and surface passivation in investigated electrolytes. Researchers have tried to work around these issues through a combination of electrolyte additives, synthesis of new material morphologies, galvanic protection, and changing the material chemistry by moving away from traditional electrolytes. Each of these approaches have had moments of promise, but they also come with their own limitations and challenges that have practical implications – including practically achievable energy density, rate capability, materials and manufacturing cost, and lifetime. Another complicating factor is that the technical literature (publications and patents) often present only an overwhelmingly sunny outlook for a given approach or technology, even when such an outlook is not reasonably supported by data. This makes it very difficult to understand which of the approaches that have been tried have the potential to be deployed in practical, commercial batteries. This presentation will systematically present and analyze the main deployments of Al anodes in both primary and secondary batteries using aqueous and non-aqueous electrolytes. The focus of this talk with be to be quantitative with regards to the practically-achievable energy density and lifetime of some of the most promising aluminum technologies from the literature and to provide a critical assessment of the state of the field today and the future for Al in primary and secondary energy storage.

30 May 2021 in ECS Meeting Abstracts
Verified
Journal Article
Closed access
EFEhsan Faegh
Ehsan Faegh
BNBenjamin Ng
Benjamin Ng
BLBrian Lenhart
Brian Lenhart
WMWilliam Mustain
William Mustain
Zn-MnO2 alkaline batteries have been a reliable primary battery system for several decades due to their inherent safety, low cost and acceptable performance at low current densities 1. However, the discharge capacity and energy density of primary Zn-MnO2 alkaline batteries has plateaued and there is a high desire to improve these performance metrics to broaden the applications of alkaline batteries. One possible way to enhance the discharge capacity of alkaline batteries is to replace Zn anodes with other anode materials that possess a higher theoretical capacity. Among different elements that could be used in battery systems, Al can offer high theoretical gravimetric and volumetric capacity compared to Zn (2980 mAh g-1 vs. 820 mAh g-1 and 8.05 Ah cm-3 vs. 5.85 Ah cm-3, respectively) 2. Al is also highly naturally abundant and low cost. However, Al is fundamentally more unstable than Zn in alkaline media due to high rates of corrosion and passivation 3. Therefore, the complete replacement of Zn with Al anodes would not be viable and practical. In this work, partial inclusion of Al in Zn anodes was explored through synthesizing hexagonal-shaped Zn-rich electrolytic Zn/Al (e-Zn/Al). In three-electrode cells with excess electrolyte, it was shown that the Al capacity was accessible within these morphologies resulting in higher discharge capacities compared to pure electrolytic Zn (e-Zn) 4. The corrosion of e-Zn and e-Zn/Al was controlled by including ZnO and Al(OH)3 as electrolyte additives. Moreover, the fundamental effects of the two electrolyte additives on corrosion and passivation of Zn surfaces were investigated using an electrochemical quartz crystal microbalance. Finally, in cylindrical full cells with limited volume (i.e. more realistic conditions), it was found that the discharge capacity and energy density of e-Zn were increased by 53% (581 mA g-1 anode) and 56% (~784 Wh kg-1 anode), accordingly, through partial Al inclusion (e-Zn/Al anodes). This was accompanied by a superior cycle performance in secondary full cells (>800 h ~ 200 cycles at C/20 and 10% depth of discharge). References Faegh, E.; Omasta, T.; Hull, M.; Ferrin, S.; Shrestha, S.; Lechman, J.; Bolintineanu, D.; Zuraw, M.; Mustain, W. E., Understanding the Dynamics of Primary Zn-MnO2 Alkaline Battery Gassing with Operando Visualization and Pressure Cells. Journal of The Electrochemical Society 2018, 165 (11), A2528. Faegh, E.; Ng, B.; Hayman, D.; Mustain, W. E., Practical assessment of the performance of aluminium battery technologies. Nature Energy 2020. https://doi.org/10.1038/s41560-020-00728-y Faegh, E.; Shrestha, S.; Zhao, X.; Mustain, W. E., In-depth structural understanding of zinc oxide addition to alkaline electrolytes to protect aluminum against corrosion and gassing. Journal of Applied Electrochemistry 2019, 49 (9), 895-907. Faegh, E.; Ng, B.; Hayman, D.; Mustain, W. E., Design of Highly Reversible Zinc Anodes for Aqueous Batteries Using Preferentially Oriented Electrolytic Zinc. Batteries & Supercaps 2020, 3 (11), 1220-1232.